Programming AVEX R6
using the Learning Method
STEP 1: Line up the AVEX R6 to the remote control you want to ‘learn’ from,
STEP 2: On the AVEX R6, press the Component button that you want to program (in this case the button that says TV) and the SELECT [SEL] button at the same time. Hold down both buttons for 2 sec- onds until the TV Component button light turns on. This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over.
STEP 3: Press any button on the AVEX R6 that you want to teach a command to. For example, if you want to teach the MUTE button on the AVEX R6 the TV Mute command from the other remote, first press the MUTE button on the AVEX R6 and the TV com- ponent button LED light will blink once indicating that the AVEX R6 is ready to learn the command.
STEP 4: Press and hold the MUTE button on the other remote until the component button LED
on the AVEX R6 blinks twice. Now you can continue learning all other buttons from your old remote by pressing the next button on the AVEX R6 and repeating this step.
Note: The component LED will blink five times if there was an error in the learning process. In this case, please repeat Steps 3 and 4.
Page 14