Universal Remote Control R6 manual

STEP 5: Once the AVEX R6 has learned all the buttons in the selected component mode, press and hold the Component button and SELECT [SEL] but- tons at the same time to save the learned functions. The component LED light will blink three times to confirm the programming. Now test all the buttons to make sure they learned correctly.

Repeat Steps 1-5 to program any other component modes.

If the Learning Method does not work, here are a few suggestions:

•If you have a Plasma TV, move to another room

•Avoid programming under fluorescent light or direct sunlight

•Put new batteries in the old remote

•Gradually vary the distance between the two remote controls

•Tap the button on your old remote instead of pressing and holding it during the learning process

Here are some additional facts regarding the Learning process:

• Learned functions override any existing pre-programmed functions on the remote control

•Learned functions are automatically erased when a new function is learned on the same button

•Learned functions are retained even after a different set-up code number is programmed into the remote control

•To return to an original pre-programmed function, a learned function must to be erased

Page 15