SETTING UP FOR TV, VCR, CABLE BOX AND SATELLITE RECEIVER
1.Turn on the device you want to control (TV,
VCR, cable box, satellite receiver etc.).
2.Press and hold SETUP until the LED indicator lights steadily. Release the SETUP button.
3.Press and release mode button for the device you want to control. The LED blinks once. Use AUX1 or AUX2 for CD equipment.
4.Enter the 3 digit Code from the Code List (separate sheet). The LED turns off after the last digit entered.
5.Point the remote at the device and press the POWER button. Your device should turn off.
6.Turn your device on and press CHANNEL+. If the device responds, setup is complete.
NOTES:
For CD players use the AUX 1 or AUX 2 buttons.
If your TV/VCR/Cable Box/Satellite Receiver does not respond, try the other codes for your brand. If it still doesn’t respond, try the Code Search method on page 10.
If the LED blinked rapidly when you entered the code, you may have entered an invalid code. Recheck the code in the code list (separate sheet) and try again.
If some buttons do not operate your equipment, try one of the other codes for your brand.
8