Step 1: Hooking up the system (continued)
7Follow the instructions below to set the color system according to your TV. The factory setting is AUTO.
Make sure the power is off each time before setting the color system. After you set the color system, the power turns on automatically and the function is set to CD.
If your TV automatically changes the color system according to the input signal:
Press ?/1 while holding down X. The color system is set to AUTO.
AUTO automatically changes the color system of the video output according to the color system of the current VIDEO CD.
If the color system of your TV is NTSC:
Press ?/1 while holding down >. The color system is set to NTSC.
If the color system of your TV is PAL:
Press ?/1 while holding down .. The color system is set to PAL.
Note
When you set color system to NTSC and play back a VIDEO CD recorded in the PAL color system, the picture image may be distorted depending on the disc. Similarly, when you set color system to PAL and play back a VIDEO CD recorded in the NTSC color system, the picture image may be distorted depending on the disc.
To connect optional components
See page 46.
To deactivate the demonstration
When you set the time (see “Step 2: Setting the time”), the demonstration is deactivated.
To activate/deactivate the demonstration again, press DISPLAY while the system is off.
To attach the front speaker pads
Attach the supplied front speaker pads to the bottom of the speakers to stabilize the speakers and prevent them from slipping.
Positioning the speakers (MHC-VX77 only)
Before you connect them, determine the best location for your speakers.
1 Place the front speakers at an angle of 45 degrees from your listening position.
Front | Front |
speaker | speaker |
(L) | (R) |
| 45º |
Surround | Surround |
speaker | speaker |
(L) | (R) |
2 Place the surround speakers facing
each other at about 60 to 90 cm above your listening position.
Surround
speaker 60 to 90 cm
6