There is severe hum or noise.
•A TV or VCR is placed too close to the stereo system. Move the stereo system away from the TV or VCR.
The sound from the connected source is distorted.
•If “VIDEO” appears in the display when you press MD (VIDEO), switch the display to “MD” (see “Note: Connecting a VCR” on page 47).
“0:00” (or “12:00 AM”) flashes in the display.
•A power interruption occurred. Set the clock and timer settings again.
The timer does not function.
•Set the clock correctly.
DAILY 1, DAILY 2, and REC do not appear when you press the CLOCK/TIMER SELECT button.
•Set the timer correctly. •Set the clock.
The remote does not function.
•There is an obstacle between the remote and the system.
•The remote is not pointing in the direction of the system’s sensor.
•The batteries have run down. Replace the batteries.
There is acoustic feedback.
•Decrease the volume level.
•Move the microphone away form the speakers or change the direction of the microphone.
The color irregularity on a TV screen persists.
•Turn off the TV set once, then turn it on after 15 to 30 minutes. If the color irregularity still persists, place the speakers farther away from the TV set.
“PROTECT”and “PUSH POWER” appear alternately.
•A strong signal was input. Press ?/1 to turn off the power, leave the system turned off for a while, then press ?/1 again to turn on the power.
•Check the speaker cables in case “PROTECT” and “PUSH POWER” appear alternately again after you turn the system on.
Speakers
Sound comes from one channel or unbalanced left and right volume.
•Check the speaker connection and speaker placement.
Sound lacks bass.
•Check that the speaker’s + and – jacks are connected correctly.
VIDEO CD/CD Player
There is no picture.
•Check that the player is connected securely.
•Make sure you operate the TV correctly. •Make sure you set the color system
correctly, according to your TV (color) system.
•Press CD.
The CD tray does not close.
•The CD is not placed properly.
The CD will not play.
•The CD is not lying flat in the disc tray. •The CD is dirty.
•The CD is inserted label side down. •Moisture condensation has built up.
Remove the CD and leave the system turned on for about an hour until the moisture evaporates.
Play does not start from the first track.
•The player is in program or shuffle mode. Press PLAY MODE repeatedly until “PGM” or “SHUFFLE” disappears.
“OVER” is displayed.
•You have reached the end of the CD. Turn SHUTTLE counterclockwise.
continued
51