Toshiba 72HM195, 62HM195 Specifications, Edid = Enhanced-Extended Display Identification

Page 106

Chapter 11: Appendix

Specifications

NOTE:

This model complies with the specifications listed below.

Designs and specifications are subject to change without notice.

This model may not be compatible with features and/or specifications that may be added in the future.

Television System

NTSC standard

ATSC standard (8VSB)

Digital Cable (64 QAM, 256 QAM; in-the-clear, unencrypted*)

*Encrypted channels can be viewed on this TV using a CableCARD. ª See page 12 for details.

Channel Coverage VHF: 2 through 13 UHF: 14 through 69

Cable TV: Mid band (A-8 through A-1, A through I) Super band (J through W)

Hyper band (AA through ZZ, AAA, BBB) Ultra band (65 through 94, 100 through 135)

Power Source

120 V AC, 60 Hz

Power Consumption

265 W (average)

38 W in standby mode (Using a CableCARD)

34 W in standby mode (Without a CableCARD)

Audio Power

15 W + 15 W

Speaker Type

56HM195: Two 4-3/4-inch (12cm) round

62HM195: Four 4-3/4-inch (12cm) round

72HM195: Four 4-3/4-inch (12cm) round

Video/Audio Terminals

S-VIDEO INPUT:

Y: 1 V(p-p), 75 ohm, negative sync.

C : 0.286 V(p-p) (burst signal), 75 ohm

VIDEO/AUDIO INPUT:

VIDEO: 1 V(p-p), 75 ohm, negative sync.

AUDIO: 150 mV(rms) (30% modulation equivalent, 22 k ohm or greater)

ColorStream¨ (component video) HD INPUT:

Y: 1V(p-p), 75 ohm

PR: 0.7 V(p-p), 75 ohm

PB : 0.7 V(p-p), 75 ohm

AUDIO: 150 mV(rms), 22 k ohm or greater

Suggested formats: 1080i, 480p, 480i, 720p

_________

** E-EDID = Enhanced-Extended Display Identification

Video/Audio Terminals (continued)

HDMIª INPUT:

HDMI compliant (type A connector) HDCP compliant

E-EDID** compliant

Suggested formats: 1080i, 480p, 480i, 720p

HDMI Audio: 2-channel PCM; 32/44.1/48 kHz sampling frequency; 16/20/24 bits per sample

VIDEO/AUDIO OUTPUT (also for recording):

VIDEO: 1 V(p-p), 75 ohm, negative sync.

AUDIO: 150 mV(rms) (30% modulation equivalent, 2.2 k ohm or less)

VARIABLE AUDIO OUTPUT:

0–300 mV(rms) (30% modulation equivalent,

2.2 k ohm or less)

G-LINK:

3 V(p-p), 3.5 mm mono socket (IR blaster cables supplied)

IEEE1394 INPUT/OUTPUT:

IEEE1394 compliant 4-pin

DIGITAL AUDIO OUTPUT:

Optical type

TheaterNetª OUTPUT:

3 V(p-p), 10 k ohm

Dimensions

56HM195: Width: 51-11/16 inches (1,313 mm) Height: 36-3/16 inches (919 mm) Depth: 16-15/16 inches (430 mm)

62HM195: Width: 57-1/16 inches (1,450 mm) Height: 39-1/4 inches (997 mm) Depth: 18-3/4 inches (476 mm)

72HM195: Width: 65-13/16 inches (1,672 mm) Height: 44-1/16 inches (1,119 mm) Depth: 21-11/16 inches (551 mm)

Weight

56HM195: 90 lbs (40.8 kg)

62HM195: 103 lbs (46.7 kg)

72HM195: 122 lbs (55.3 kg)

Supplied Accessories

Two dual-wand IR blaster cables

Remote control with two size “AA” alkaline batteries

Owner’s Manual (this book)

Optional Stands: 56HM195: ST5685 62HM195: ST6285 72HM195: ST7285

106

 

Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

 

 

#01E_103-109_566272HM195

106

7/28/05, 5:08 PM

Black

(E) 56/62/72HM195

Image 106
Contents 56HM195 62HM195 72HM195 This TV is not Intended for USE with a PC Safety PrecautionsDisposal of mercury may be regulated due to 56HM195 ST5685 62HM195 ST6285 72HM195 ST7285For replacement of the obsolete outlet Important Safety InstructionsInstallation, Care, and Service On nextLamp in this product has a limited service life. Frequent or continuous, unplug the power cordContact a Toshiba Authorized Service Center Never attempt to service the TV yourselfContents 103 Using the TV Guide On Screenª110 Introduction Features of your new TVWelcome to Toshiba Install the batteries in the remote control See LED indications onTV front and side panel controls and connections Connecting your TVPower Press to turn the TV on and off See LED indications on page 99 for additional information7 !¡ TV back panel connectionsComputer PC. This TV is not intended for use with a PC Overview of cable types To a Personal Computer PCYou will need ¥ In Canada, call TCL Customer Service atFor more information, call your local cable operator To view encrypted digital channelsConnecting a VCR and antenna or Cable TV no Cable box Connecting a camcorderTwo sets of standard A/V cables Connecting a VCR and Cable boxOn Screen recording features To view basic and premium Cable channelsFrom antenna Connecting a VCR and satellite receiverSelect the ColorStream HD-1 video input source on the TV From satellite dishTo view premium Cable channels To view the DVD playerSelect the ANT 1 video input source on the TV Your TV has ColorStream component video inputsTo view antenna or Cable channels To record a TV program while watching a DVDSelect the ANT-1 video input source on the TV Connecting two VCRsTo view the antenna or Cable signal To view VCRSee ÒSetting the Hdmi audio modeÓ on Connecting an HDMIª or a DVI device to the Hdmi inputOne Hdmi cable type a connector per Hdmi device To connect an Hdmi device, you will needTV’s Digital Audio OUT terminal outputs a Dolby Connecting a digital audio systemConnecting an analog audio system To control the audioTo connect the IR blaster cable TheaterNetª on-screen device controlTo control the devices Supported signals Connecting IEEE1394 video devicesUsing analog-compatible IEEE1394 devices Using TheaterNetª on-screen device controlWhen you connect a D-VHS or Avhd device to the TV IEEE1394 device initializationTo edit the IEEE1394 device information IEEE1394 device managementHighlight the device you want to edit and press Enter See Chapter LINKª connectionTo connect to the G-LINK ª terminal LINKª IR blaster cable wand approx inch from deviceUsing the remote control Learning about the remote controlRemote control effective range Point remote control toward remote sensor on front of TVTo install the remote control batteries Installing the remote control batteriesDevice mode control after programming Remote Control functional key chart PowerAudio VCR Mute Searching and sampling the code Device code setupDevice FunctionsRepeatedly press Mode to select CABLE/SAT mode Using the volume lock featureOperational feature reset To reset the volume controls to the original device modeCable boxes Multi-brand remote control device codesVCRs/PVRs Brand CodeLaser disks CD playersReceivers DVD playersMenu layout and navigation Main menu layoutExit Setup / Installation menu layoutNavigating the menu system Menu Enter ExitConfiguring the location of your TV TV Guide On Screen setupSetting up the TV Guide On Screenª system To set up the TV Guide On Screenª systemFor additional details, see On nextSetting up the TV Guide On Screenª system After testing and you TV Guide On Screenª ReminderTo configure the ANT 1 and ANT 2 input sources Setting up your TVTo select the menu language Programming channels automatically Programming channels into the TVÕs channel memoryTo program channels automatically Manually adding and deleting channels in the channel memory List To clear your favorite channel listsTo add and delete channels in the Favorite Channels sets Picture multi-window for the current ANT inputTo set up TheaterNet device control Setting up and using TheaterNetª on-screen device controlSetting up TheaterNet To remove a device from TheaterNetTo close the on-screen control icons Using the TheaterNet control iconsTo select the deviceÕs control icons directly To view another sourceLaser disk players TheaterNetª IR device codesAmplifiers Miscellaneous audio devicesVideo accessory Hdtv decoder Receivers VCRs ADCSTS To set the Hdmi audio mode Setting the time and dateSetting the HDMIª audio mode To set the Avhd device skip timeViewing the CableCARDª menu Setting the Quick Restartª FeatureTo set the Quick Restartª feature To view the CableCARDª menuRestore Factory Defaults Viewing the system statusRating, stereo, HDTV, new episode To open the TV Guide On Screenª systemLineup so your favorite stations are listed first Menu Info TV Guide Enter Down TV Guide On Screenª remote control functionsNavigating the TV Guide On Screenª system REC SplitPanel Menus Video WindowTo lock/unlock the Video Window Hdtv Info BoxTV Guide On Screenª Icons Show is presented in high-definition TV, if availableListings screen TV Guide On Screenª ServicesEpisode Options panel menu Search screen Example Category searchList of all matching shows for that keyword is displayed Example Keyword searchTo edit or delete a keyword To choose the way recordings are displayed For additional details, see ÒRecord featuresÓ onRecordings screen To view a recording, you can do one of the followingSet a show to Record from a panel menu Record featuresSchedule screen Record icons Record conflictRecording notification banner Remind features Remind conflict Reminder notification bannerRemind icons Change system settings Setup screenChange channel display Record defaults Change default optionsGeneral defaults Remind defaultsTo select the video input source to view Using the TV’s featuresSelecting the video input source to view ¥ The source can be Òhidden.Ó See page 68 for detailsTo label the video input sources Labeling the video input sourcesDTV Satellite/DSS Cable Game Console To clear the input labelsTo toggle between Browse mode and Select mode Tuning channelsUsing the Channel Browserª To tune to a channel in Browse modeTo set a channel as Home using the menus Setting a channel as the ÒHomeÓ channel for an inputTo set a channel as Home using the remote control Adding and clearing channels in the channel historySwitching between two channels using Channel Return Tuning your favorite channelsTuning to the next programmed channel Switching between two channels using SurfLockªYou can view many program formats in a variety of picture Selecting the picture sizeNatural picture size To select the picture sizeTheaterWide 1 picture size For 43 format program Scrolling the TheaterWide picture onNone of the picture is hidden TheaterWide 2 picture size for letter box programsTo turn off the auto aspect ratio feature To set the scroll settingsTo turn on the auto aspect ratio feature TheaterWide 2 and 3 onlyTo set the Cinema Mode to Video Selecting the lamp modeTo set the Cinema Mode to Film To select the lamp modeTo display a program in the POP window Using the POP featuresUsing the POP double-window feature To close the POP window and tune to the highlighted windowSwitching the speaker audio main or POP POP double-window aspect ratioTo scan and tune your favorite channels Using the Freeze featureUsing the favorite channel scan feature Highlight the window for the channel you want to viewSelecting the picture mode Adjusting the pictureAdjusting the picture quality CableClear/DNR field, select your desired setting Using CableClear¨ /DNR digital noise reductionSelecting the color temperature To select the color temperatureTo select the Mpeg noise reduction level Using Mpeg noise reductionUsing dynamic contrast To select dynamic contrast preferencesTo view captions or text Using the closed caption modeAdvanced closed captions To view text Highlight T1, T2, T3, or T4Digital closed captions To select digital closed captionsMuting the sound Adjusting the audioUsing the digital audio selector Selecting stereo/SAP broadcastsUsing the sub-bass system SBS Adjusting the audio qualityUsing the StableSound¨ feature Turning off the built-in speakers Using the SRS WOWª surround sound featureSelecting the optical audio output format Memory card specifications Using the media playerMedia Specifications Jpeg file specificationsUsing the Jpeg picture viewer Media player specificationsTo set the slide show interval Using the Jpeg picture viewerDuring the slide show To close the picture viewerTo use the mute function Using the MP3 audio playerMemory card care and handling To close the MP3 audio playerSetting the On/Off Timer Setting the sleep timerUsing the Gray Level feature Understanding the auto power off featureUnderstanding the last mode memory feature Displaying TV setting information on-screen using RecallIf you cannot remember your PIN code Using the Locks menuEntering the PIN code Changing your PIN codePress z to highlight Edit Rating Limits and press Enter Blocking TV programs and movies by rating V-ChipTo block and unblock TV programs and movies Edit Rating Limits screen below appearsUnlocking programs temporarily Blocking channelsLocking video inputs Using the GameTimerª Using the control panel lock featureTroubleshooting Closed caption problems Symptom SolutionSAP mode may be on. Set the MTS feature to Stereo mode Rating Blocking V-Chip problemsLED indications TV Guide On Screenª FAQs Setup101 TV Guide On Screenª FAQs On Screen ª system?Replacing the lamp unit When to replace the lamp unit Lamp unit replacement and careAppendix Grasp the lamp unit handle and gently pull the lamp unit How to replace the lamp unitOr serious injury U.S., call Tacp consumer solutions at 1-800-631 Disposing of the used lamp unitSpecifications Edid = Enhanced-Extended Display IdentificationLimited One 1 Year Warranty on Lamp Unit Limited United States WarrantyLimited One 1 Year Warranty on Parts and Labor How to Obtain Warranty ServiceLimited Canada Warranty How to Obtain Warranty Services109 87-90 IndexChannel programming 12-25Picture-out-picture POP Picture adjustmentsRemote control 106Manufactured by 05-08