Toshiba 62HM195, 72HM195 owner manual Manually adding and deleting channels in the channel memory

Chapter 6: Setting up your TV

Programming channels into the TVÕs channel memory (continued)

Manually adding and deleting channels in the channel memory

After automatically programming channels into the channel memory, you can manually add or delete individual channels.

To add or delete channels in the channel memory:

1.Press MENU and open the Setup menu.

2.Highlight Installation and press ENTER. (A new set of Installation menu icons will appear on-screen, as shown in step 3).

Setup

Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio		Auto
HDMI 2 Audio		Auto
Slide Show Interval		2 Sec
AVHD Skip Time		15 min
Navigate	Select CH RTN Back EXIT Exit

3.Open the Terrestrial menu, highlight Channel Add/Delete, and then press ENTER.

Terrestrial

Input Configuration

Channel Program

Channel Add/Delete

Signal Meter

Navigate Select CH RTN Back EXIT Exit

4.The illustration below left shows channels programmed for the ANT 1 antenna input. To view the list of channels programmed for the ANT 2 or Cable box antenna input, press the y z buttons to highlight either “ANT 2” or “Cable Box” and press ENTER.

Note: ÒCable BoxÓ will appear only if you connected a cable box to your TV.

Channel Add/Delete			ANT 1	Channel Add/Delete			Cable Box
	2	Analog	ANT 1		1	Analog	ANT 1

2 - 1	Digital	ANT 2	2	Analog	ANT 2
2 - 2	Digital	Cable Box	3	Analog	Cable Box

3	Analog		4	Analog
4	Analog		5	Analog
5	Analog		6	Analog
6	Analog		7	Analog
7	Analog	Reset	8	Analog	Reset
7 - 1	Digital	Cancel	9	Analog	Cancel

8 Analog Done 10 Analog Done

To add a channel to the channel memory:

Highlight the unchecked box next to the channel number you want to add, and then press ENTER to check the box.

To manually add digital subchannels on a physical channel:

Use the Channel Numbers and the Dash (–/100) on the remote control to enter the channel number (for example, 56–1).

If the channel is found, the number will be added to the list and the box will be checked.

If the channel is not found, a message will appear.

To remove a channel from the channel memory:

Highlight the checked box next to the channel number you want to remove, and then press ENTER to uncheck the box.

To save your new settings:

Highlight Done and press ENTER.

To revert to your original settings:

Highlight Cancel and press ENTER before saving.

To remove all channels from the channel memory:

Highlight Reset and press ENTER, and then highlight Done and press ENTER.

Note:

¥This action applies to the current antenna input only. To delete/add channels on the other input, highlight the input you want (ANT1 or ANT 2) and press ENTER.

¥This action cannot be cancelled unless you highlight Cancel and press ENTER before saving your changes.

Channel Add/Delete			ANT 1
	2	Analog	ANT 1
	2 - 1	Digital	ANT 2
	2 - 2	Digital	Cable Box
	3	Analog
	4	Analog
	5	Digital
	6	Analog
	7	Analog	Reset
	7 - 1	Digital	Cancel
	8	Analog	Done

		Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.	43
#01E_041-043_566272HM195	43	7/28/05, 4:28 PM
	Black

(E) 56/62/72HM195