Toshiba TLP-S10 owner manual Connection, Placement Styles, Before connection

Placement

Placement Styles

As shown in the figures below, this device can be placed in 4 different styles.

The factory setting is “floor-mounted front projection.” Set the placement style in the default setting menu p.30 , in accordance with your needs.

Connection

Before connection

• Read the owner’s manual of the device to connect to the projector.

• Some types of computer cannot be used or connected to this projector.

Check for an RGB output terminal, supported signal p.38 , etc.

• Turn off the power of both devices before connecting.

Floor-mounted front projection

Floor-mounted rear

projection

Ceiling-mounted front

projection

Ceiling-mounted rear

projection

• The figure below is a sample connection. This does not mean that all of these devices

can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)

CRT monitor, etc. Computer

CAUTION

•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit.

•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.

•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that.fact.

Projection Distance and Screen Size

Use the figures, tables, and formulas below to determine the screen size and projection distance. (Screen sizes are approximate values for full-size picture with no keystone adjust- ment)

To audio output

Audio cable	To RGB
(for computer)
	output
(supplied)

RGB cable (supplied)

		COMPUTER-	VIDEO
AUDIO	MONITOR	( Y/PB/PR )	VIDEO S-VIDEO	CONTROL

Monitor cable Mini D-sub 15P-BNC

(not supplied)

Preparations

As seen from above	projection size (inches) – 0.8668
Screen	a =		25.81
90°	screen size		projection distance a (m)
	(cm)
	40	(102)	1.52
	60	(152)	2.29
	80	(203)	3.07
As seen from the side	100	(254)	3.84
	150	(381)	5.78
Lens center	200	(508)	7.72

To audio output White (L) Red (R)

Audio cable
(supplied)
To Y/CB/CR output		S-Video cable
		(not supplied)
Green (Y)
Blue (CB),		Video cable
Red (CR)	Yellow
		(supplied)
	(to video output)
	To audio

Conversion	output
adapter	White (L)	To S-Video
BNC-pin	Red (R)
(not supplied)		output

Control cable

p.40

To RS-232C terminal

90°	250 (635)	9.65
	300 (762)	11.59

a

a is the distance (m) between the lens and the screen, and corresponds to a range of 1.52 m to 11.59 m.

DVD player VCR Computer (for control)

Note

• The AUDIO terminal can be used with all the devices for input terminal.

18 19