Toshiba TLP-S10 Control terminal, Separately Sold Product, Pin assignment, Interface format

Page 21

Specifications (Continued)

■CONTROL terminal

●Pin assignment

			Pin No.	Signal Name	Description
	7		1	RXD	Receiving data
8	6		2	CTS	Consent to send
			3	DSR	Data set ready
5		3	4	GND	Signal ground
5		3	5	RTS	Request to send
			5	RTS	Request to send
	4		6	N.C	No connection
2	1		7	TXD	Sending data
			8	N.C	No connection

Mini DIN 8 pin connector

●Interface format

1

Communication method

RS-232C, 9600bps, No Parity, Data Length: 8 bits;

Stop Bit Length:

1 bit

2

Communication format

STX (02h)

Command (3Byte)

ETX (03h)

Only 1 command valid per communication.

3

Data format

For input commands, only ASCII-compliant all-uppercase

alphanumeric characters supported.

4

Replies

Acknowledge

ACK (06h)

CR (0Dh)

Data

... Normally ended

ACK (06h)

ESC (1Bh)

... Aborted

No acknowledge

NAK (15h)

If commands are to be sent consecutively, wait for the response from the projector before sending the next command.

● Main Commands

Item	Command
Power on	PON
Power off	POF
Icon display on	MO0
Icon display off	MO1
Auto setting (RGB input)	PAT
Status display on	DON
Status display off	DOF

Item	Command
Computer input select	IN1
Y/PB/PR input select	IN2
Video input select	IN3
S-video input select	IN4

Note

•Contact your dealer for control cable and other commands.

■Separately Sold Product

Replacement Lamp

Model TLPLV3

Note

• Design, specifications, etc. subject to change without notice for improvements, etc.

40

Image 21

Contents TLP-S10 Svga Others Maintenance Operations Preparations Before UsingPower Sources Safety Precautions Important Safety InstructionsSource of Light VentilationImportant Safety Instructions Damage Requiring Service Before UsingReplacement Parts Safety CheckImportant Precautions Power Supply Cord SelectionPlace and Manner of Installation Label LocationsOther Cautions and Informations Exemption ClausesContents Preparations Installing Acrobat ReaderViewing the manual Audio cable for a VCRInto the remote control Preparing and using the remote controlLoading dry-cell batteries Operating the remote ControlPlacement Styles PlacementConnection Before connectionConnecting the power cord Turning the power on and offTurning the power off Turning the power onOperations Basic operationsZooming out the images Using handy featuresFreezing the image Freeze Using handy featuresUsing the menus How to use the menusDisplaying Information Status display Image adjustment menu Using the menuDefault setting menu Display setting menuLens and main unit cleaning Air filter cleaningLamp replacement MaintenanceTrouble indications Lamp replacementSpecifications Before calling service personnelList of general specifications OthersList of supported signals RGB signals SpecificationsList of supported signals Y/PB/PR signals List of supported signals Video, S-Video signalsControl terminal Main CommandsSeparately Sold Product Pin assignment