Toshiba 22LV505C, 19LV505C owner manual Precautions, Choosing a location for your LCD TV

Page 6

Introduction

Precautions

Choosing a location for your LCD TV

Retractable pedestal stand and locating the LCD TV

Observe the following safety precautions:

1)Ensure that unpacking and transfer of the unit is carried out by two or more people.

2)Put the LCD TV on a large level area in a recumbent posture.

3)Grab the pedestal stand and lift the display up. Confirm the pivot is

locked.

4) Place the TV on a sturdy, level surface that can support the weight of the TV.

5)Be sure to secure the TV to a wall stud, pillar, surface, or other immovable

structure. To secure the TV in this manner:

(1) attach a clip to an immovable structure,

then (2) pass a sturdy strap through the clip and attach each end to the hooks located

at the back of the TV. Be sure to leave at least 4 inches between the TV and the wall or similar structure for ventilation. See item 19, page 4 for additional details.

To fold the pedestal stand

1)Slide the lever on the back side of the pedestal stand to the left.

2)Lay the display down.

Slide the lever to the left

Back side of the pedestal stand

NOTE: Do not operate the LCD TV while the pedestal stand is folded.

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a UL Listed wall bracket appropriate for the size and weight of the LCD TV (see page 2):

1)CAUTION: Two people are required for installation.

2)Unplug and remove any cables and/or other component connectors from the rear of the TV.

3)Follow the instructions provided with your wall bracket. Before proceeding, make sure the appropriate bracket(s) are attached to the wall and the back of the TV as described in the instructions provided with the wall bracket.

4)After attaching the appropriate bracket(s) to the wall and the back of the TV, remove the pedestal stand from the TV as described below.

Removing the Pedestal Stand

1)Carefully lay the front of the unit face down on a flat, cushioned surface such as a quilt or blanket. Leave the stand protruding over the edge of the surface.

NOTE: Extreme care should always be used when removing the pedestal stand to avoid damage to the LCD panel.

2)Remove the two screws shown in the diagram below. This will allow removal of the pedestal stand.

3)Once you have removed all two screws holding the pedestal stand in place, remove the pedestal stand from the TV by sliding the pedestal stand away from the TV.

Important notes about your LCD TV

The following symptoms are technical limitations of LCD Display technology and are not an indication of malfunction; therefore, Toshiba is not responsible for perceived defects resulting from these symptoms.

1)An after image (ghost) may appear on the screen if a fixed, non-moving image is displayed for a long period of time.

The after image is not permanent and will disappear in a short period of time.

2)The LCD panel contained in this TV is manufactured using an extremely high level of precision technology; however, there may be an occasional pixel (dot of light) that does not operate properly (does not light, remains constantly lit, etc.). This is a structural property of LCD technology, is not a sign of malfunction, and is not covered under your warranty. Such pixels are not visible when the picture is viewed from a normal viewing distance. Note: Interactive video games that involve shooting a “gun” type of joystick at an on-screen target may not work on this TV.

Notes on handling

Do not subject the LCD panel to physical shock, such as dropping it. It may cause unit damage and malfunction.

When shipping the unit, the original shipping carton and packing materials come in handy. For fully protection, repack the unit as it was originally packed at the factory.

Do not use volatile liquids, such as insecticide, near the unit.

Do not leave rubber or plastic products in contact with the unit for prolonged periods of time.

Doing so will leave marks on the finish.

The top and rear panels of the unit may become warm after a long period of use. This is not a malfunction.

When the unit is not in use, always remove the disc and turn off the power.

Notes on locating the unit

When you place this unit near a TV, radio, or VCR, the playback picture may become poor and the sound may be distorted. In this case, place the unit away from the TV, radio, or VCR.

To avoid damage to this product, never place or store the TV/DVD in direct sunlight; hot, humid areas; or areas subject to excessive dust or vibration.

Two screws

6

50S0301A.indb 6

2/5/08 5:58:18 PM

Image 6
Contents 19LV505C 22LV505C Ownerʼs RecordChild Safety Location of the required Marking IntroductionInstallation Manufacturer, or sold withSafety Instructions Precautions Choosing a location for your LCD TVImportant notes about your LCD TV Structure of disc contents Precautions /Notes on discsOn cleaning discs On handling discsAbout this ownerʼs manual On Video CDsPlayable discs Contents Identification of controls FrontSide Rear Antenna jackRemote control DVD Menu buttonInserting batteries OperationAntenna connections Cable TV connections ConnectionsConnecting to optional equipment Using the audio/video inputsConnecting to an optional equipment with S-video output Ex. VCR with S-VideoEx. DVD player with Component video Back side Connecting to an amplifier equipped with a DTS decoderDolby Digital Digital Theater Systems DTSConnecting to an Hdmi or a DVI device Channel digital stereoPower source Connecting to optional equipment Power sourceConnecting to a PC Personal Computer To use AC power sourcePress or to select Signal Type, then Auto SetupAuto Setup Press or to select Air or CableSetting the language Setting the languagePress or to select Language To memorize channels Air/Cable selectionAutomatic search Press or to select Add/Delete, then Press or Enter Add/Delete channelSelect Channel, then press or Enter Press or to select the channel that you Want to skipAdding Channel Clear AllTV operation TV operationMute CH RTN OperationPress or Enter Ch Label menu will appear Labeling channelsPress or to select Ch Label, then Press or to select a channel you want to label, then pressSelect Setup, then press or Enter Labeling video inputsPress or to select Video Label, then press or Enter Setting the closed captions Press or to select CC Setting, then press or to select OnCC advanced CC advancedAdjusting the picture preference/ Picture settings Adjusting the picture preferencePicture settings Theater Wide1 picture size for 43 format programs Viewing the wide-screen picture formatsViewing the wide-screen picture formats Theater Wide2 picture size for letter box programsFilm Mode/DNR Film ModePress or to select Film Mode Press or to select On or OffPicture control adjustment in the PC mode Picture control adjustment in the PC modePress INPUT, then press / or 4 to select Select Audio , then press or Enter Sound control adjustmentSelecting Stereo/Second Audio Program SAP Select Audio, then press or EnterSelecting the audio language Selecting the Hdmi audio input sourceAdjusting the back lighting Using the aspect feature Adjusting the back lightingUsing the aspect feature Select Setup , then press or EnterResetting your settings Setting the Auto Shut Off Resetting your settingsSetting the Auto Shut Off Press or to select ResetPlaying a disc Vcdcd Basic playbackVCD Basic playback Basic playbackDVD Playing in slow-motion Vcdcd Playing in fast reverse or fast forward directionsDvdvcd Playing frame by frame VCD Locating a chapter or trackZooming/Locating desired scene VCD ZoomingVCD Locating desired scene Dvdvcd Marking the scenes To cancel the MarkerMarking desired scenes Dvdvcd Returning to the scenesRepeat playback/A-B Repeat playback Dvdvcd Repeat playbackVCD A-B Repeat playback Program playback/Random playback VCD Program playbackCD Random playback Title selection Changing angles/Title selection/DVD menuChanging angles DVD menuPress Audio Select during playback Changing soundtrack language/SubtitlesDVD VCD Changing soundtrack language Subtitles Case of Video CD playbackDvdvcd Disc status Press Play Mode in the stop modeDisc status/To turn off the PBC VCD To turn off the PBC seeLimitations on MP3/WMA/JPEG/DivX CD playback MP3/WMA/JPEG/DivX and Audio CD operationCD Audio CD/MP3/WMA/JPEG/DivX CD information Limitations on displayCD MP3/WMA and Audio CD playback file browser screen will appear on the screenSelect Files CD Jpeg playback CD Slide show playback MP3/WMA/JPEG/DivX and Audio CDOperation PreparationPress / to select file CD Playing DivX VOD contentCD DivX playback Press Stop to end playbackCD Repeat playback Audio CD/ MP3/WMA/JPEG/DivX Repeat, random and program playback using file browserfile browser, press / / / to select Repeat during stop mode CD Random playback Audio CD/ MP3/WMA/JPEG/DivXCD Program playback Audio CD/MP3/WMA/JPEG/DivX Program ViewCustomizing the function settings VCD Setting procedureThen press or ENTER. The selectable settings will appear Setting details Other Menu, Subtitle, AudioEnglish, Francais, Espanol Original AudioOff Night ModeDigital Out BitstreamIf you forget the password Parental control settingSet the new password DivX VODDVD Temporary cancel the rating level by DVD disc Playback will commence if the entered password is correctLoad a DVD disc Understanding the Power Return feature TroubleshootingMake sure the connection of AC cord is secured Symptoms Possible Solutions DVD OthersReception disturbances IgnitionLanguage code list Language Name CodeSpecifications Model 19LV505C 22LV505C GeneralYour Responsibility Limited One 1 Year Warranty on Parts and LabourLimited Warranty for Commercial Units Others Rental UnitsDisclaimer and Limitation of Remedy Arbitration and Dispute ResolutionHow to Obtain Warranty Services Critical Applications