REFERENCE
ANT Lets you switch the source of the video signal from DSS® satellite signals to an
TRANSPORT Buttons (REW, STOP, PLAY, FF, PAUSE, REC) Use when controlling an auxiliary device, such as a VCR or Laserdisc player. Note that the REC (record) button is used for
FETCH Brings up the
Programming the Remote Control
The DSS® remote can be programmed to control most brands of remote controllable TVs, VCRs, and cable boxes.
Programming the Remote to Control Your TV
To determine whether your remote needs to be programmed, turn the TV on, point the remote at the TV, and press the TV button. Then press CHAN UP or DOWN to see whether the TV responds to the remote commands.
Follow these steps to program your remote to control your TV.
1.Turn on the TV.
2.Look up your brand and code number(s) on the TV Code list on page 54.
3.Press and hold the TV button.
4.Enter the
5.Release the TV button and press OFF•ON or CHAN UP/ DOWN to see if the TV responds to the remote commands. If it doesn’t, try the next code listed for your brand.
6.Repeat these steps until the TV responds to the remote commands.
This remote may not operate all models of the brands that are shown. Use the codes shown in this manual, or on the sheet packed with your remote.
After you program the remote to control your TV, record your TV code here for easy reference.
51