GE 45601 manual Adding an Event, Random Events, Disabling an Event, Deleting an Event

Page 13

events such as turning on or off your lights at a preset time and day. You must set the time and date before programming an Event.

Adding an EVENT:

1.Press and hold SETUP until the screen displays LGHT SETUP.

2.Use either Arrow key to scroll until the display reads EVENTS.

3.Press OK and the Screen will display ADD.

4.Press OK and the Screen will display EVERY DAY. Use Either Arrow key to change this option to MON-FRI,SAT-SUN, ONE TIME or a specific Day of the WEEK.

5.Once you have chosen the Event profile, press the OK key.

6.The Screen will now display SEL DIGIT.

7.Press any digit and the screen will display the EVENT number.

8.Press and release OK and the screen will display ENABLED.

9.PRESS OK and the Screen will display EVENT TYPE.

10.Use either arrow key to scroll between the LIGHT, SCENE or GROUP options (Pressing DIGITS 1-9will adjust the LIGHT number accordingly).

11.After you select the EVENT type, press the OK key and the screen will display ON TIME.

12.Pressing ON or OFF with the 1 key will adjust the hour.

13.Pressing ON or OFF with the 2 key will adjust the minutes.

14.Pressing ON or OFF with the 3 key will toggle between AM and PM.

15.Press the OK key once you have programmed the ON TIME and the screen will display OFF TIME.

16.Pressing ON or OFF with the 1 key will adjust the hour.

17.Pressing ON or OFF with the 2 key will adjust the minutes.

18.Pressing ON or OFF with the 3 key will toggle between AM and PM.

19.Once you have programmed the OFF time press OK and the screen will display SUCCESS.

Random EVENTS:

The 45601 Advanced Remote allows you to program automated events such as turning on or off your lights at a predetermined time and day. By choosing the RANDOM option, the EVENT will start at +/-15 minutes of the Scheduled Time.

To activate this function, after step 8 above, use either arrow key to scroll until the display reads RANDOM. Press OK and the Screen will display EVENT TYPE. Continue the programming as shown in step 10 above.

Disabling an EVENT:

Once an event has been programmed, it can be disabled by following steps 1-8 above and then scrolling to DISABLED and pressing OK.

Deleting an EVENT:

1.Press and hold SETUP until the screen displays LGHT SETUP.

2.Use either Arrow key to scroll until the display reads EVENT.

3.Press OK and the Screen will display ADD.

4.Use either arrow key to scroll until the screen displays DELETE.

5.Press OK and the Screen will display SEL DIGIT.

6.Press the DIGIT for the EVENT you want to DELETE.

7.Press OK and the screen will display SUCCESS.

Image 13
Contents Advanced Remote Menu Selection Buttons IntroductionEasy to use LCD menu system Additional features includeWave Terminology Battery Use and Safety Installing BatteriesTo Install Batteries Type of Construction Wireless RangeAdding a Device NODE/LIGHT to the Network Controlling Individual Lights Devices / Nodes Setting a Light’s Brightness LevelTurning a Light On or Off Removing AN Individual Device Light / Node From Your RemoteGroups Deleting a Device Light / Node from Your NetworkTo create or add a device to a group To control a GroupScenes Deleting a GroupAdding a Light Device / Node to a Scene To control a sceneRemove Removing a Light Device / Node from a SceneDeleting a Scene LabelsEvents Time and Date SetupRandom Events Adding an EventDisabling an Event Deleting an EventTo Change Advanced Configuration Settings Advanced ConfigurationThermostats Adding a ThermostatTo send information to a secondary remote Sending Information to a Secondary RemoteCopying Information to this Remote Recovering Network Information SetupUpdate Network Information Primary Controller Shift TransferFCC Notice Interoperability with Z-WaveDevicesFCC ID MG345601 Compliance with IC Rules and Regulations Object is subject to the following two conditionsWarranty Page Remote