Nozzle Housing And Short Hose Replacement, Removal

NOZZLE HOUSING AND SHORT HOSE REPLACEMENT

Removal
1.	Remove the lower plate as outlined in the LOWER
PLATE REMOVAL/INSTALLATION section.
2.	Remove the belt and agitator assembly as outlined in
the respective sections.
3.	Remove the nozzle hose by pulling it up out of the
nozzle housing and then pulling it, while twisting, out of
the wand holder.
4.	Insert a flat blade screwdriver between the nozzle	(Fig. 10)
housing and the plastic shaft, pry out the plastic shaft as
illustrated, (Fig. 10).

5. Remove the nozzle housing as illustrated, (Fig 11).

6. Remove the handle release assembly as outlined in its removal section.

7.Remove the light cover, (Fig. 12) by removing the two (2) screws from

the nozzle housing and pushing out on the cover (Fig. 12).

8. Remove window, furniture guard and slider support.

NOTE: If the motor case cover is removed, DO NOT turn vacuum		(Fig.11)
over as the motor may fall out.
Installation	Handle Release	Cover
		Light
1. Install the light cover, handle release assembly, furniture guard,	Assembly

window and slider support in the new nozzle housing. (Fig. 12).
2. Fit the nozzle from the motor shaft side first and rotate it into	Furniture
place on the dust container as illustrated, (Fig. 13).	Guard
	Guard

3.Slide the plastic shaft through the nozzle housing and into the dust container. Make sure that the slot on the bottom of

the plastic shaft is down and fitted onto the projection.	Light Cover Screws
4. Reassemble the nozzle hose by inserting it into the wand holder	(Fig. 12)

then place the other end into the nozzle housing with the tab fitting into the slot.

5.Install the belt, agitator assembly, and the lower plate according to the respective instructions.

- 8 -

(Fig. 13)

Plastic

Shaft

Nozzle

Housing

Projection

(Fig. 14)

- 13 -