GE 45601 manual Thermostats, Adding a Thermostat, Controlling a Thermostat Deleting a Thermostat

THERMOSTATS

Adding a Thermostat:

The 45601 Advanced Remote allows you to program and control a Z-WAVE enabled Thermostat.

1.Press and hold SETUP until screen displays LGHT SETUP.

2.Use either arrow key to scroll until the screen displays THERMOSTAT.

3.Press OK and the screen will display ADD.

4.Press OK and the screen will display SETUP WAITING.

5.Press the button on the thermostat’s Z-Wave interface.

6.When the screen displays SUCCESS, you have successfully added the THERMOSTAT to your remote control.

Controlling a Thermostat:

The features and functions that can be controlled vary by manufacturer and you will need to review the user manual that was provided to determine capabilities of your THERMOSTAT. If supported by the thermostat, the 45601 Advanced Remote allows you to check room temperature, adjust HVAC system modes (Heat, Cool, Auto, Fan, etc.) and adjust temperature settings (setpoints). Please note that your HVAC system may have to be set to “HEAT or “COOL’” mode in order to remotely check and/or adjust the room temperature.

Deleting a Thermostat:

1.Press and hold SETUP until screen displays LGHT SETUP.

2.Use either arrow key to scroll until the screen displays THERMOSTAT.

3.Press OK and the screen will display ADD.

4.Use either arrow key to scroll until the screen displays DELETE.

5.Press OK and the screen will display SETUP WAITING.

6.Press the button on the thermostat’s Z-Wave interface.

7.When the screen displays SUCCESS, you have successfully deleted the thermostat.

ADVANCED CONFIGURATION

Some Z-Wave devices provide advanced capabilities available only through the use of a remote control like the 45601 Advanced Remote. One example is the 45606 in-wall dimmer which allows the end user to create 3 different dim rates depending upon how the dimmer is activated (manually, via a normal Z-Wave “Dim” command or via an All-On or All-Off Z-Wave command). Each of the three can be set anywhere between 10 milliseconds and 4.2 minutes for the time it takes to go from full intensity to minimum intensity.

Please refer to the instructions of your Z-Wave device for available options and specific instructions on changing its advanced configuration.

To Change Advanced Configuration Settings:

1.Press and hold SETUP the screen displays LGHT SETUP.

2.Use either Arrow key to scroll until the display reads ADV CONFIG.

3.Press OK and screen will display PARAM 0.

4.Use either Arrow key to scroll until the display reads the proper parameter number (1 - 255) as indicated in the Z-Wave device’s instructions.

5.Press OK and the screen will read NUM BYTES.