GE 24914 instruction manual Code Identification, Reset to Factory Settings

Using Your Remote, cont.

Volume Feature.

3. Press and release the MUTE button.

4. Press and release the VOL button. The red indicator light will blink twice and go off.

Code Identification

1. Press and hold the SETUP button until the red indicator stays on (approximately 4 seconds) and then release the button.

2. Press and release the desired device button (TV, DVD, CBL/SAT, DVR/AUX) you would like the code for.

3.Press and release ENTER button.

4.Press and release the #1 button. Count the number of times the

remote light flashes. This is the number corresponding to the first digit of the code. Repeat the process by pressing the #2, #3 and #4 buttons for the remaining digits.

5.Press and release ENTER button to exit this mode.

Reset to Factory Settings

1. Press and hold the SETUP button until the red indicator stays on (approximately 4 seconds) and then release the button.

2. Press and release the MUTE button.

3.Press and release the number #0 button. The red indicator light will flash twice.

12