Installation Guidelines

3.Call your electric power company. Tell them your plans and ask them to come look at your proposed installation. This is a small inconvenience considering your life is at stake.

4.Plan your installation carefully and completely before you begin. Successful raising of a mast or tower is largely a matter of coordination. Each person should be assigned to a specific task and should know what to do and when to do it. One person should be in charge of the operation to issue instructions and watch for signs of trouble.

5.When installing your antenna, remember:

a.Do not use a metal ladder.

b.Do not work on a wet or windy day.

c.Do dress properly—shoes with rubber soles and heels, rubber gloves, long sleeved shirt or jacket.

6.If the assembly starts to drop, get away from it and let it fall. Remember, the antenna, mast, cable, and metal guy wires are all excellent conductors of electrical current. Even the slightest touch of any of these parts to a power line complete an electrical path through the antenna and the installer: you!

7.If any part of the antenna system should come in contact with a power line, do not touch it or try to remove it yourself. Call your local power company. They will remove it safely.

8.If an accident should occur with the power lines call for qualified emergency help immediately.

Because the antennas transmit and receive radio signals, they are susceptible to RF obstructions and common sources of interference that can reduce throughput and range of the device to which they are connected. Follow these guidelines to ensure the best possible performance:

•Mount the antenna as high as possible to take advantage of its propagation characteristics.

•Keep the antenna away from metal obstructions such as heating and air-conditioning ducts, large ceiling trusses, building superstructures, and major power cabling runs. If necessary, use a rigid conduit to lower the antenna away from these obstructions.

•The density of the materials used in a building’s construction determines the number of walls the signal must pass through and still maintain adequate coverage. Consider the following before choosing the location in which to install your antenna:

–Paper and vinyl walls have very little affect on signal penetration.

–Solid and pre-cast concrete walls limit signal penetration to one or two walls without degrading coverage.

–Concrete and wood block walls limit signal penetration to three or four walls.

–A signal can penetrate five or six walls constructed of drywall or wood.

–A thick metal wall causes signals to reflect, causing poor penetration.

•Install the antenna away from 5-GHz cordless phones. These products can cause signal interference because they operate in the same frequency range as the device your antenna is connected to.

Cisco Aironet 5-GHz 14-dBi Directional Antenna (AIR-ANT5114P2M-N)

4	78-20958-01