Loewe Connect 32 Full-HD+ 100, Connect 37 Full-HD+ 100 Managing stations, TV stations

Managing stations

TV stations

Various options for managing stations are available via the TV menu. For example the description for TV stations. For radio stations the same applies, except that the Radio menu is called in Radio mode (see also page 36).

➠Station management is not possible if a programmed timer recording is still pending.

➠If at least one station is locked the access code must be entered before Search/Update (see Parental lock on page 41).

Search/update stations – Search wizard

In the search/update with the search wizard, new stations are searched for which have not yet been stored.

➠You have to repeat the initial installation (see page 12) and automatically search for new ones if you want to delete all the existing stations and automatically search for new ones. Do also use the first installation if you want to change to receiving MHEG-5 stations (attend restrictions for DVB software update, see page 38).

Call TV menu.

￿￿Select Settings,

￿￿go to the menu line below.

￿￿Select Stations,

￿￿go to the menu line below.

￿￿Select Search wizard, ￿￿go to the menu line below.

In the upper info text the current search settings will now be displayed:

Search wizard

Your TV carries out the update of the station range (search for new stations; delete stations no longer broadcast) with the following settings:

Location of TV set	United Kingdom
Signal source	DVB-T

TV menu

Settings

Stations		END
Search wizard		Start search/update
Change search settings	OK

If you want to change these search settings:

￿￿Select Change search settings, OK￿wizard prompts search settings.

If you agree with these settings:

￿￿Select Start search/update, OK￿start search.

Red button: Abort current search/update.

Downloaded From TV-Manual.com Manuals

Explanations of some search settings, including the upgradeable satellite reception:

Set location	Select the country for country-specific defaults and sta-
	tion sorting.
Signal source	Here select antenna, cable, or satellite, depending on
	where you want to search for new stations.
	Here you can also call a configuration of the DVB-T and
	DVB-S antennae with the green button (see page 13).
Antenna/cable:	With selection of set location the conventional TV
TV/colour	standard/colour standard is the default. This should only
standard	be changed if stations with other standards are to be
	searched.
Encrypted	You can state whether coded stations are to be searched
stations	for in the search/update. Select yes then coded stations
	are also searched for. However, these stations can only
	be received in connection with a CA module and the ap-
	propriate Smart Card. Ask your dealer which Smart Card
	you need to receive certain stations. Handling of the CA
	module is described on page 40.
DVB-T	If you want to run the station search independently of
Search method	the channel grid, select frequency search for the search
	method.
DVB-C	With the selection of set location the conventional set-
Settings	tings will be preset. Only change this if you know other
	symbol rates and modulation types or if you have to
	specify the network ID for your cable network (informa-
	tion available from your cable network provider).
	If you want to run the station search independently of
	the channel grid, select frequency search for the search
	method.
DVB-S	If you want to run the station search independently of
Settings	the channel grid, select frequency search for the search
	method.
	The symbol rate is specified by the satellite provider and
	normally does not need to be adjusted.

- 26