Kenwood CX-SR10 Installing on Convertibles, Routing the cables around the trunk lid rim

Page 10

Installing on Convertibles

On convertibles the antenna module should be located on the centerline of the trunk approximately 6 inches from the rear window.

WARNING: Mounting the antenna on the trunk will only work with convertibles. For all other types of vehicles mount the antenna on the roof.

Figure 18: Mounted on trunk of convertible

1.Follow steps 1 to 4 under "Installing on Sedans" to attach the antenna module to the vehicle.

2.Route the cable from the rim further underneath the lid (use some telephone wire clips) to the cable channel. Attach the cable to the cable channel with some zip ties.

Figure 19: Routing the cables around the trunk lid rim

Figure 20: Attaching the cable to the cable channel

10

Image 10
Contents CX-SR10 Page Introduction Environmental dataGeneral Instructions Mechanical dataShortening the antenna tail Installing on Sedans Installed antennaCables routed separately Entering the trunk through cable channel Cable routing along the trunk rubber molding Installing on Convertibles Routing the cables around the trunk lid rimEntering the interior through the cable channel Installing on SUVs, Minivans and 5-Door Vehicles Minivan with Antenna ModuleHiding the cable under the rubber molding Mounting on Pickup Trucks Brakelight cavityPage Kenwood