Kenwood CX-SR10 Installing on SUVs, Minivans and 5-Door Vehicles, Minivan with Antenna Module

Page 12

Installing on SUVs, Minivans and 5-Door Vehicles

The antenna module should be located on the centerline of the roof, not less than 4 inches from the gap between the roof and tailgate:

Figure 23: Minivan with Antenna Module

Note the following:

If the vehicle is equipped with a roof rack, the crossbar should be placed at least 6 inches away from the antenna module.

Figure 24: Preferred mounting location

It may be necessary to locate the antenna to the right or left of center in order to avoid "skid ribs" or brake light.

Figure 25: "Skid Ribs" and brakelight

Other roofs have a brakelight in the back and the cable may be routed through the brakelight (see “Mounting on Pickup Trucks”).

1.Follow steps 1 to 4 under "Mounting on Sedans" to attach the antenna module to the vehicle.

12

Image 12
Contents CX-SR10 Page Introduction Environmental dataGeneral Instructions Mechanical dataShortening the antenna tail Installing on Sedans Installed antennaCables routed separately Entering the trunk through cable channel Cable routing along the trunk rubber molding Installing on Convertibles Routing the cables around the trunk lid rimEntering the interior through the cable channel Installing on SUVs, Minivans and 5-Door Vehicles Minivan with Antenna ModuleHiding the cable under the rubber molding Mounting on Pickup Trucks Brakelight cavityPage Kenwood