Installation and Configuration
Performing Power On Self Test
Perform these steps to complete POST and Operating System software initialization:
Note This procedure is written assuming that you have connected the CLI console to the controller as described in “ Connecting and Using the CLI Console.”
Step 1 Plug an AC power cord into the rear of the controller, and connect the other end to a grounded 100 to 240 VAC 50/60 Hz electrical outlet.
Note Cisco supplies country specific standard power cord if you order it with the controller; be sure the controller end of the cord conforms with the IEC 320 standard.
Note If you wish to run a previous version of the controller code, press the <ESC> key immediately after the Model and S/N line. This will take you to the Bootloader Boot Options Menu.
Step 2 Monitor the controller bootup using the CLI screen:
The Bootup script displays Operating System software initialization (code download and POST verification) and basic configuration as shown in the following sample bootup display:
.o88b. d888888b .d8888. | .o88b. | .d88b. |
| |||||
d8P | Y8 | `88' | 88' | YP | d8P | Y8 | .8P | Y8. |
8P |
| 88 | `8bo. |
| 8P |
| 88 | 88 |
8b |
| 88 | `Y8b. | 8b |
| 88 | 88 | |
Y8b | d8 | .88. | db | 8D | Y8b | d8 | `8b | d8' |
`Y88P' Y888888P | `8888Y' | `Y88P' | `Y88P' | |||||
Model S/N:
Press <ESC> now for additional boot options...
(If desired, press <ESC> now to display the Bootloader Boot Options Menu.)
Boot Options
Please choose an option from below:
1.Run active image (version 3.0.80.0)
2.Run backup image (version 3.0.57.0)
3.Manually perform system upgrade
4.Clear Configuration
Please enter your choice:
(Enter 1 to run the current Code, enter 2 to run the previous Code, enter 4 to run the current Code and clear the controller configuration to factory defaults. Do not enter 3 unless directed to do so by Cisco Technical Assistance Center (TAC).)
BOOT Uncompressing RTOS Image ... OK
Loading Code at f0100000 ...
Relocating Code to 0785e000, end 07fa649e ... OK
Detecting hardware . . . .
(This may take a long time. Do not reboot the controller at this time.)
(The rest of this process takes two to three minutes. Do not reboot the controller until you receive the user login prompt.)
Software Copyright 2004 <company name> All rights reserved.
Cisco 4100 Series Wireless LAN Controllers - Installation and Configuration Guide
10 |
| |
|
