NETGEAR ANT24D18 manual Wall Mount with Adjustable Bracket, Wall Mount with Fixed Bracket

Wall Mount with Adjustable Bracket

	2 plastic
	screws
	bracket B
	2-screw
	washer
screw	tube
	screw nut

screw tube screw nut

bracket A

washer

Wall Mount with Fixed Bracket

Now, Connect the Antenna

The instructions below cover outdoor and indoor installations.

Connecting the Antenna for an Outdoor Installation

1.Turn off your wireless unit.

2.Connect the provided 2-meter cable to the antenna and to the arrestor as shown here. You can connect the cable to either of the two RF ports on the lightning arrestor.

Wireless unit's	18 dBi Patch Panel
DC block
	Directional Antenna
	ANT24D18

	Wireless unit	N/SMA adapter
		Lightning	2m cable
5-12V DC	ETHERNET	arrestor
	RESET		(provided)

	NETGEAR cable
Ethernet	ACC-10314-01, 02, 03, 04, 05
	(Sold separately)
(CAT 5) cable
	Ground cable	Building
	(Not provided)
		grounding

3.Connect the grounding cable (not included) from the lightning arrestor to the ground of the building.

Grounding cable: The grounding cable must be equivalent or better than: AWG 10, UL 1015, Stranded, 600 V, 105°C, green or green/yellow insulation, 2 clip of 5.5 mm inner diameter cramped at both ends, cable no longer than 5 meters.

Warning: the lightning arrestor and appropriate ground cable must be used for outdoor installation. NETGEAR does not assume any responsibility in case of hazard resulting of non-compliance with these instructions.

4.Screw the N/SMA Reverse Adapter on the lightning arrestor (clockwise) on the second RF port. Connect a NETGEAR cable model ACC-10314-01, 02, 03, 04 or 05 (sold separately) to the adapter.

5.Locate the primary detachable antenna on the wireless access point. Remove the antenna and connect the other end of the NETGEAR cable ACC-10314-01, 02, 03, 04 or 05 to this port.

8 9