Network
I can’t connect to the network.
¾Confirm the network connection and settings. (> 10, 11, 24)
¾There may be interference that prevents the unit from detecting your home network. Place the unit and the wireless router closer to each other. This unit may be able to detect your network name (> 12, “SSID”).
¾Check the owner’s manuals for each device and connect accordingly.
When using wireless LAN connection, video from the DLNA Certified media server is not played back or video frames are dropped during playback. [BD901] [BD91]
¾Higher transfer rate router such as 802.11n (2.4 GHz) wireless router may solve the problem. If you use 802.11n (2.4 GHz) wireless router, it is necessary to set the encryption type to “AES”.
Simultaneous use with a microwave, cordless telephone etc. at 2.4 GHz may result in connection interruptions or other problems.
¾On the “Wireless Settings” screen (> 24), the continuous lighting of at least 4 “Reception” indicators is the target for a stable connection. If 3 or fewer indicators are lit or the connection is being interrupted, change the position or angle of your wireless router and see if the connection state improves. If there is no improvement, connect to a wired network and perform the “Easy Network Setting” (> 11) again.
Messages on the screen
Cannot play.
¾You inserted an incompatible disc (Discs recorded in PAL video, etc.).
Cannot display on this unit.
¾You tried to play a
¾
No disc inserted.
¾The disc may be upside down.
$This operation is not available.
¾Some operations are unsupported by the unit. (For example, reverse slow motion, etc.)
IP address is not set.
¾The “IP Address” in “IP Address/DNS Settings” is
The current wireless network security setting is weak. It is recommended to change to a stronger security setting.
¾Set a stronger network security level referring to the wireless router owner’s manuals.
POWER LED
When the POWER LED is flashing, check the message on the TV screen. If a message is not displayed on the TV screen, determine the type of the error by checking the way the POWER LED is flashing.
Flashes 6 times
¾The remote control and this unit are using different codes.
Turn on this unit by using the standby/on switch on this unit, and check “Remote control ” which is displayed on the screen when you press a button on the remote control.
Press and hold [OK] and the displayed number (“”) for at least 5 seconds.
Flashes
¾The copyright protected disc cannot be played back.
One of the devices connected to this unit (TV, amplifier, etc.) does not support copyright protection.
Flashes 3 times
¾The disc in use cannot be played back since the copyright information is invalid.
Reference
SQT0108 29