STEP 6 : Reprogramming the remote control
If you have more than one Panasonic player/ recorder and the remote control operates both products at once, you will need to change the remote control code to prevent this occurrence. (> 35, “Remote Control”)
Smart eco-sensor
This mode will decrease the power consumption when the unit is in standby mode and the sensor does not detect people close by.
Preparation
Set “Quick Start” to “On (Smart eco-sensor)” (> 35).
Sensor detection range image and operation of the unit
ASensor detection range (at i20eC) : Within a distance of approx. 5 m and an angle of 20e up and down and 30e left and right from the unit
≥The power consumption is minimal when people are out of the detection range for more than 30 minutes.
≥The following will occur when there is a movement within the detection range, such as someone walking into the room where this unit is placed.
–Speed of startup from the standby mode will increase.
–Idle power consumption will increase. (About the power consumption > 43)
BThe
≥This function does not work under the following conditions.
–For about 1 minute after connecting the AC mains lead.
–The unit is placed in a
≥The detection sensitivity may be reduced under the following conditions.
–The room temperature is close to the body temperature.
–The unit is exposed to direct sunlight or close to heating appliances.
–People are approaching straight to the unit.
–Other than listed above, temperature change or some interference, etc., can affect the detection sensitivity.
16 VQT3V87