Safety Information
Warning
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK).
NO
|
|
|
|
|
|
| CAUTION |
|
|
|
| RISK OF ELECTRIC SHOCK |
|
|
|
| DO NOT OPEN |
|
|
|
|
|
|
|
The lighting flash and Arrowhead within the | CAUTION: TO REDUCE THE RISK OF ELECTRIC | The explanation point within the triangle | ||
triangle is a warning sign alerting you of | SHOCK, DO NOT REMOVE COVER (OR BACK) | is a warning sign alerting you of important | ||
dangerous voltage inside the product. | NO USER SERVICEABLE PARTS INSIDE. REFER | instructions accompanying the product. | ||
| SERVICING TO QUALIFIED SERVICE PERSONNEL. |
|
02 Safety Information
WARNING
•To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
FCC NOTE (for U.S.A)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures.
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect this equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
•This class B digital product meets all requirements of the Canadian Interference - Causing Equipment Regulations.
FCC RF Radiation Exposure
RF Radiation Exposure Statement
This equipment complies with FCC RF Radiation Exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be
(1)This device may not cause harmful interference, and
(2)This device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be
The final device into which this transmitter module is installed must be labeled with the following statement:
“This device contains TX FCC ID: A3LDNUBS1.” If this transmitter will be configured as a pc peripheral, it will be the OEM’s responsibility
to obtain authorization as such (either through Certification of Declaration of Conformity) prior to marketing of the device.
English