–When connecting the player to an AV receiver or amplifier using an HDMI cable in order to listen to the Dolby TrueHD, Dolby Digital Plus,
Audio is not output from HDMI terminal when
Please go back and make the proper selection again.
Go Back
•Linear PCM audio signals (2 channels) are output from all terminals other than the ones selected at Audio, regardless of the audio format or the player’s settings.
5Select and set the HDMI
TOP MENU | TOOLS |
| ENTER |
HOME | RETURN |
MENU |
Setup Navigator
BD PLAYER
Select the HDMI
On |
| Off |
Normally select [On] (Recommended).
Select [Off] if the video or audio of
was not output in the test output.
When HDMI
Proceed to step 8.
6Select the output video resolution from the COMPONENT
VIDEO output terminals.
Use / to select, then press ENTER.
Setup Navigator
BD PLAYER
Select the output video resolution at the
Component video terminal.
If you select [Source Direct], the output resolution is determined according to the video format of the playing source.
For details on the resolution settings, see Switching the output video resolution on page 25.
7 Select the aspect ratio of your TV. | 03 | |
Use / to select, then press ENTER. | ||
|
Setup Navigator
BD PLAYER
Select the screen aspect ratio to match
your TV.
8 Check the settings.
Select Proceed, then press ENTER.
Setup Navigator
BD PLAYER
Select [Proceed] if you want to start testing
your audio and video settings.
Proceed
9 Output test tones.
Use / to select Yes, then press ENTER.
Setup Navigator
BD PLAYER
The test tone will be output.
Reduce the volume to an appropriate level.
Yes |
| No |
The video and/or audio may not be output under certain setup.
The setup menu comes back in 30 seconds.
Caution
•The screen in step 10 and test tones are output simultaneously according to the settings in steps 4 to 7. Lower the volume of the devices connected with the player.
21
En