Sharp BD-HP25S Before Starting Playback, Loading the Batteries in the Remote Control

Playback

Before Starting Playback

Loading the Batteries in the Remote Control

1Hold in the tab on the battery cover and pull the cover towards the direction of the arrow.

NOTE

•Do not subject the remote control unit to shock, water or excessive humidity.

•The remote control unit may not function if the Player’s remote sensor is in direct sunlight or any other strong light.

•Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries properly.

•Do not mix old and new batteries, or mix different brands.

•Remove the batteries if you will not use the remote control unit for an extended period of time.

Connecting the Power Cord

Plug the supplied AC cord into the AC IN terminal on the rear of the Player (1). Then plug into AC outlet (2).

2 Load the two “AA” size batteries (R-06 size,	Approximate operating range of
UM/SUM-3). Place batteries with their terminals	remote control
corresponding to the m and n indications in
battery compartment.	Remote control sensor

3 Insert the smaller tab of the battery cover into		15º		*Approx. 7m
the opening 1, and press down on the cover
	30º		30º
until it clicks in place 2.
		15º

WARNING Remote control unit

•Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater.

This can cause batteries to leak, overheat, explode or catch fire.

It can also reduce the life or performance of batteries.

NOTE

•Place the Player close to the AC outlet, and keep the power plug within reach.

•TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH THE UN-INSULATED PARTS OF ANY CABLES WHILE THE AC CORD IS CONNECTED.

•The B(On/Standby) indicator blinks while the Player is preparing for starting up. You cannot turn the Player on until the B(On/Standby) indicator stops blinking.

•If you are not going to use this Player for a long period of time, be sure to remove the AC cord from the AC outlet.

20