Network Connection Setting

Customizing the Function Settings

1.Press / to select Network in stop mode, then press button,

I.If no Ethernet cable is connected to the ETHERNET jack on the back of your player, a screen similar to the following appears:

Wireless

Network List

WiFi Protected Setup (WPS)

Manual

IP Settings

For detailed operations, refer to the “Conﬁguring a wireless Internet connection”.

II.If a wired connection is made to your player, a screen similar to the following appears:

Wired IP Settings

Link Status	Link up
MAC Address	00:23:18:75:b1:2b

IP Mode	Dynamic
IP Address	128.60.3.31
Subnet Mask	255.255.0.0
Gateway	128.60.1.1
Primary DNS	128.60.1.41
Secondary DNS	128.60.1.42

Apply

Cancel

Network Test

Refer to the “Conﬁguring a wired Internet connection” for details.

Note: “Wireless” and “Wired” are optional and do not appear at the same time. Normally, “Wireless” is shown without wired connection. While using a wired Internet connection, “Wireless” is disabled and “Wired” is activated.

Conﬁguring a wired Internet connection

1.Press / to select Network in stop mode, then press button to enter the following screen:

If the network connection is active, Link Up appears next to Link Status. If the network connection is not active, Link Down displays next to Link Status.

2.Press / to select IP Mode, then press OK.

3.Press / to select an IP mode. You can select:

•Manual — Lets you manually conﬁgure network settings, such as IP address, subnet mask, and gateway settings.

•Dynamic — Uses DHCP to automatically obtain an IP address.

4.Press / / / to highlight Network Test, and press OK to test your network connection.

5.Press or RETURN to go to the previous menu.

Conﬁguring a wireless Internet connection

This section describes how to conﬁgure the Blu-ray Disc™ player for accessing the internet via a WiFi connection. The procedure for connecting to a wireless network depends on various network parameters. Read the following conﬁguration methods to determine which instructions to use to connect to your network.

I.Connection to the wireless Network which you select

a.Connecting to an Unencrypted Wireless Network

b.Connecting to an Encrypted Wireless Network

II.Connection to the wireless Network using Wi-Fi Protected Setup (WPS)

a.Connecting to a Wireless Network Using WPS Pushbutton

b.Connecting to a Wireless Network Using WPS PIN

III.Connection to the wireless Network using Manual IP Conﬁguration

Description of the Wireless Network List Display

Choosing “Network List” in the wireless network setup menu will cause a list of available WiFi networks to appear, as shown below:

		Network List

	WiFi a	WiFi-me*
	WiFi b g n	Panda
	WiFi a	dlink_media
	WiFi b g	NTGR 11g
	WiFi b g	Airport_SN