Toshiba BDX2150KC owner manual Connected, Saved, Security, Protocol, Signal, Strength

Customizing the Function Settings

The symbols that might appear next to each listed wireless network in the network list are as follows:

Category Icon		Definition
Connected		When the Blu-ray Disc™
		player is turned on, it will
		connect to the wireless
		network displaying this symbol.
		Typically, this is the last
		wireless network connected
		before powering down.
		Indicates that the Blu-ray
	*	Disc™ player is currently
		connected to this network.
Saved		The wireless network
		properties have been saved
		in the Blu-ray Disc™ player’s
		memory.
Wireless		The wireless network data is
Security		not encrypted.
		The wireless network data
		is encrypted; a ‘security key’
		must be entered so that the
		Blu-ray Disc™ player can
		share data over the network.
		The wireless network data
		is encrypted; the encryption
		scheme is not supported by
		the Blu-ray Disc™ player.
Wireless	a	The wireless network
Protocol		supports 802.11a
	b	The wireless network
		supports 802.11b
	g	The wireless network
		supports 802.11g
	n	The wireless network
		supports 802.11n
		The wireless router supports
		the WPS standard.
Signal		Strong Signal
Strength
		Good Signal
		Medium Signal
		Weak Signal
		No Signal

I.Connection to the wireless Network which you select

Wireless

Network List

WiFi Protected Setup (WPS)

Manual

IP Settings

1.In the “Wireless” menu, press / to select Network List, then press OK. A list of existing wireless networks

near the Blu-ray Disc™ player will appear (It may			EN
take several seconds for this list to be created). For
example:
		Network List
	WiFi a	WiFi-me*
	WiFi b g n	Panda
	WiFi a	dlink_media
	WiFi b g	NTGR 11g
	WiFi b g	Airport_SN

2.Press / to select the desired wireless network, and press OK to confirm.

a. If the Blu-ray Disc™ player is connected to an Unencrypted Wireless Network, a menu similar to the following will appear:

WiFi-me

Connect WPS Pin Cancel

Name and Password are case-sensitive

3.Press / to highlight Connect, and press OK. If the

wireless network is functioning, icon and a message “Connection to XXX...Success” will appear on the TV.

4.Press OK to close the message. The Blu-ray Disc™ player is now connected to the network. From now on, when you turn on the player, it will automatically connect to the network; there is no need to repeat these steps again.

Note: If you do not see this message, the Blu-ray Disc™ player was not able to connect to the network.

27