Addonics Technologies PBRDRUE manual Switch Modes, Hardware Installation

Switch between internal power through USB connection or external power using included USB power cable or 110/220 5V power adapter

3 Switch Modes:

INT – Used when using USB bus power (Left position) Green LED lights up

OFF – Pocket Drive is turned OFF (Middle position)

EXT – Used when using External Power adapter (Right position) Green LED lights up

Note: It is recommended to use the external power adapter when burning Cd’s

,DVD’s or Blu-ray. The switch must be positioned in EXT mode.

To read CD, DVD’s or Blu-ray it is fine to use USB bus power and the switch is in INT mode.

The Addonics Driver Disk included with the product is for Windows 98 & 98SE drivers only.

Hardware Installation

1.Connect the power adapter to the power connector located at the back of the enclosure.

2.Connect the data cable using

a.eSATA connection

Note: You should have configured the eSATA host controller on your system before you connect the writer. Once the eSATA host controller is configured, do the following steps below.

Plug-in the eSATA cable to the eSATA port on the enclosure and attached the other end to your eSATA host controller.

b.Or USB2.0 connection

Attach the USB cable to the USB port on the enclosure and in your system.

3.Power ON the enclosure using the switch on the back panel. You should see the Green Power LED on the top light up.

4.Go to Device Manager to check if your system detects the Blu-ray drive via eSATA connection

Blu-ray/DVD-

ROM Drive

Sample driver of an eSATA host controller

via USB2.0 connection

Blu-ray/ DVD-ROM

Drive

USB Driver