Rear panel connections

1Digital outputs

Optical and Coaxial digital audio outputs, normally used to connect to a suitable Audio/Video Receiver for surround sound decoding (output must be set for "Bitstream" - refer to the "Audio setup" section). These outputs can also be used to connect to a separate DAC or digital recording device (output must be set for "LPCM" - refer to the "Audio setup" section).

Toslink Optical - Use a high quality TOSLINK ﬁbre optic cable.

S/P DIF Co-Axial Digital - Use a high quality 75 ohm digital RCA/Phono interconnect cable designed speciﬁcally for digital audio use.

77.1 channel analogue audio output

If Down-mix is set to "7.1 CH" in the Speaker Setup page (Down-mix mode section) of the 650BD’s Setup menus, these sockets provide 7.1 output from the 650BD's built in Surround-Sound decoder. This can be used to connect to the 7.1 audio line-level inputs of an ampliﬁer/AV receiver or ampliﬁed speaker package if required. Similarly, Down-mix can be set to "5.1 CH" to provide 5.1 output. If Down-mix is set to "LT/RT", "Stereo" or "V.Surround" the Left and Right outputs only are active and provide a stereo or stereo downmixed output. Refer to the "Speaker conﬁguration" section of this manual for more information.

2Analogue video outputs

Component - Connect to the YCbCr or YPbPr terminals of a television set via three 75 ohm RCA/phono cables designed speciﬁcally for video use.

Composite - Connect to your television via 75 ohm RCA/phono cable designed speciﬁcally for video use.

S-Video- Connect to your television via dedicated S-Video cable.

8AC power socket

Once you have made all audio and video connections, plug the IEC type AC power cable into the rear of the unit and an appropriate mains socket then switch on. Your 650BD is now ready for use.

3HDMI Out

HDMI (High-Deﬁnition Multi-Media Interface) is a purely digital connection that can carry both audio and video. Use a dedicated HDMI cable to connect to a TV/Monitor or AV Receiver with a compatible HDMI input.

4IR (Infra-Red) Emitter In

Allows modulated IR commands from multi-room systems or IR repeater systems to be received by the unit.

5Ethernet LAN port

Used for discs supporting BD-Live that provide interactive features when the player is connected to the Internet.

6USB port

Port for interfacing to a ﬂash/memory card or "Mass Storage Device".

Notes:

•Only USB 2.0 certiﬁed products with the USB 2.0 logo on them are supported by the 650BD. Please either consult the manufacturer of the USB 2.0 product to make sure it is properly certiﬁed, or go to www.usb.org for a list of approved products, before purchase. We cannot be held responsible for any incompatibility issues.

•This unit supports "USB Mass Storage Class Bulk-Only Transport" devices only. Most USB thumbs drives, portable hard disk drives and card readers conform to this device class. Other USB devices such as MP3 players, digital cameras, and mobile phones may not be compatible.

•Supported USB drives must be formatted with the FAT (File Allocation Table) or FAT32 ﬁle system. Drives formatted with NTFS ﬁle system are not supported.