Harman-Kardon BDS770 owner manual Setting Up the Receiver

BDS 270/BDS 570

Preparing the Remote Control and Setting Up the Receiver

Programming Remote Control “Punch-Through” Commands

After programming the remote to control an auxiliary (Aux) component, you can also program it so it will control the Aux component’s channel up/down and transport functions (Play, Pause, etc.) even when the remote is not in the Aux-control mode. For example, if the remote is programmed to operate your TV in the Aux control mode, you can also have the TV’s channel +/– functions “punch through” and operate even when the remote is in the Disc, Radio or iPod control modes.

1.Press and hold the Input button for the main device the remote will be operating. The button will light up, go dark and then light up again. Release the button.

2.Select the type of punch-through programming.

a)For “punch-through” channel control, press the Channel Up button.

b)For “punch-through” transport control, press the Play button.

3.Press the Aux button. The original Input button will flash to confirm.

You can repeat Step 1 – Step 3 for any of the remote’s Input buttons (Aux, Radio, etc.). NOTE: “Punch-through” channel and transport commands will override the existing commands for those buttons in the source modes you program.

To undo “punch-through” programming, follow the same steps as above, but press the same Input button in Step 1 and Step 3.

Erasing All Learned Button Codes

1.Press and hold the Options button for more than three seconds. The remote’s Aux Input button will light up.

2.Press the Aux Input button. The button will flash.

3.Hold down the “9” number button for at least three seconds, three times in a row. The Aux Input button will flash three times then will go out. All learned button codes have now been erased.

Resetting the Remote to Factory Default Condition

1.Press the Aux Input button and the “0” number button simultaneously. The Aux button will light up.

2.Hold down the “3” number button for at least three seconds, three times in a row. All of the input buttons will flash three times.

3.After the input buttons stop flashing, all remote programming has been erased and the remote is reset to its factory default programming.

Using the Remote After it is Programmed

Pressing the remote’s Aux Input button will put the remote into the auxiliary-control mode, and it will control the auxiliary component(s) via the codes you have programmed into it.

To switch the remote back to the BDS receiver-control mode from the auxiliary-control mode, press any of the other Input buttons or the Home button.

Setting Up the Receiver

NOTE: The menu screens shown in this manual are for illustrative purposes and may differ somewhat from the actual displays.

To set up your BDS receiver, you will use the remote to navigate through all of the on- screen menus and to make selections from them.

•• Use the Cursor Up/Down buttons to navigate through the menu list. When an item is highlighted, a blue border will appear around it.

•• To select a highlighted item, press the OK button. The screen will change depending on your selection.

•• To return to the previous screen, press the Previous button.

Setup Wizard

Welcome to the Harman/Kardon BDS Setup

Wizard.

Some simple information is needed to ensure you get the best experience from your product.

You can adjust these settings later in addition to making changes to more advanced settings by selecting ‘Settings’ from the Home Menu.

OK Next

Before you can use your BDS receiver, you need to set the language and make a few basic settings so that its video output will work properly with your TV. Press the OK button and the Wizard’s language screen will appear.

After setting the language you want the on-screen menus to appear in, press the OK button and the Wizard’s TV-resolution screen will appear.