Harman-Kardon BDS770 owner manual Supplied Accessories, Receiver Front-Panel Controls

BDS 270/BDS 570

Supplied Accessories and Receiver Front-Panel Controls

Supplied Accessories

If any of these items are missing, please contact Harman Kardon Customer Service via www.harmankardon.com.

English

Remote Control

EJECT POWER TV

AAA Batteries

Disc slot: Insert a compatible disc into the slot. The BDS receiver’s disc player will accept 5-inch (12cm) and 3-inch (8cm) discs.

Information display: Various messages appear on this display in response to commands and in order to show the audio/video that is playing, the BDS receiver’s settings or other aspects of the BDS receiver’s status as described throughout this manual.

Eject button (on top of unit): Press this button to eject a disc from the BDS receiver’s built-in disc player. Before pressing this button, make sure no objects are blocking the disc-slot opening. NOTE: If you do not remove the ejected disc within 90 seconds, it will automatically re-load back into the disc player for protection.

Standby button (on top of unit): This button toggles the receiver between the On and Standby modes.

Power indicator: This LED surrounds the Standby button. When the BDS receiver is plugged into AC power, the LED turns amber to indicate that the receiver is in Standby mode (ready to be turned on). When you turn the BDS receiver on (by the Standby button or the remote control’s Power button), the LED turns white.

Headphone jack: Insert the 1/8-inch (3.5mm) stereo mini connector from a set

of headphones into this jack. NOTE: When a plug is inserted into the Headphone jack, the BDS receiver’s speaker outputs automatically mute; the HDMI audio output remains active.

Volume control: Rotate the disc clockwise to raise the volume; rotate counterclockwise to lower the volume. The volume level will appear on the Information display.

IMPORTANT: Do not turn the receiver’s Volume control up to or past the point where the audio from the speakers becomes distorted. Doing so can damage the speakers.

USB 2.0 port: Gently insert a flash drive or HDD disk drive with a USB Standard-A cable to this port.

IMPORTANT: Do not connect a PC or other USB host/controller to this port, or you may damage both the BDS receiver and the other device.

Orient the device’s plug so it fits all the way into the BDS receiver’s USB connector. You may insert or remove the device at any time – there is no installation or ejection procedure.