RCA RCU404 manual Program for Dvdaux Direct Entry Method

CODE INDICATOR

SEARCH LIGHT

DVD• (BLINK)

AUX

INDICATOR

LIGHT

1.Manually turn on the component you wish to assign to the DVD•AUX key (TV, VCR, DVD, DBS System or cable box).

2.Locate the enclosed DVD code list, or the corresponding code list for the auxiliary component (TV, VCR, DBS, or cable box).

Note: If your brand isn’t listed, use one of the Code Search methods to program this remote control (See Code Search on page 9).

3.Press and hold the CODE SEARCH key until the INDICATOR LIGHT illuminates, then release the CODE SEARCH key.

4.Press and release the DVD•AUX key. The INDICATOR LIGHT will blink.

5.To program for DVD, press the

VCR key. For an auxiliary component, press the corresponding component key (TV, VCR, DBS•CABLE).

The INDICATOR LIGHT will blink again, then remain lit.

1 2 3

4 5 6

7 8 9

0

(OFF)

ON•OFF

6.Use the number keys on the remote to enter the first code listed for your brand.

After you enter a valid three-digit code, the indicator light turns off.

Note: If you enter an invalid code, the LED will flash rapidly for

2 seconds. Start over at step 3.

7.Aim the remote at your component and press the ON•OFF key. If your component turns off, you have found the correct code.

DVD•AUX CODE

✓ TV VCR CABLE DBS DVD

8.Enter the code in the box provided on this page for future reference.

9.If your component doesn’t turn off, repeat steps 3-7 above, entering the next code for your brand.

If none of the codes work or your brand is not listed, use one of the Code Search methods to program this remote (See Code Search on page 9).

For a description of each key on the remote control, refer to the Key Descriptions section page 3-4.