COMPLETING THE INSTALLATION:
After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety features of the system:
1.If you have not done so already, place the red rubber handle cover over the handle of the control switch for ease of identification. This will allow your customer to distinguish the Remote Start control switch from the program switch.
2.Mount the control module up and behind the dash securing it in place with cable ties or screws. Be certain that the chosen mounting location will not inhibit any of the controls of the vehicle.
3.Securely harness and tie all wiring up and away from all hot and moving parts that they may come in contact with under the dash board or in the engine compartment areas.
CAUTION: Particularly avoid the area around the steering shaft and column, as wires can wrap around these mechanisms and impair the safe operation of the vehicle.
4.Apply the Caution Labels supplied with this kit to a conspicuous area in the engine compartment. Make sure to clean the surface before affixing the label.
5.Check the vehicle's wipers, lights, horn, etc.... to insure proper operation.
6.Replace all panels that were removed during installation, and retest the system.
7.Explain all activated features and safety systems associated with Remote Start Unit installed to the customer.
8.Place the Valet Switch Tag and or the Remote Start Control Switch Tag on their respective switches and point these out to the customer.
18
128-7767
18 of 19