Universal Electronics CABLE 4 manual Tv/Vcr

Atlas Manual rev2 12/27/02 11:07 AM Page 10

PROGRAMMING TV/VCR COMBO CONTROL

3. (continued)

NOTE: If the VCR key did not blink twice after enter- ing the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

If you’ve located a TV/VCR setup code that works your TV/VCR Combo and a separate TV code is also listed, you’ll need to program this code into the remote control to access volume control (see Programming Device Control on page 8).

4. Aim the remote control at your TV/VCR Combo and press POWER once. The device should turn off. If it does not respond, repeat steps 2-3 (starting on the previous page), trying each code listed for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 20).

5.For future reference, write down each working device code in the boxes below:

TV/VCR

TV (if used)

10