Programming TV/VCR Combo Control

Atlas Manual rev2 12/27/02 11:07 AM Page 9

NOTE: If the selected mode key emits a long blink, the code is invalid. Repeat steps 2 through 3 and try entering the same code again.

4. Aim the remote control at the device and press POWER once. The device should turn off. If it does not, repeat steps 2-3, trying each code for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 20).

NOTE: If the device does not have a POWER key, press the (Play) key.

5.Repeat steps 1 through 4 for each device you want the the remote control to control. For future reference, write down each working device code in the following boxes:

AUD

Audio Device ____________________

VCR

CBL

If you own a TV/VCR Combo, perform the following instructions to control this device:

1.Turn on your TV/VCR Combo and insert a video cassette.

2. On the remote control, press VCR once. Press and hold SETUP until the VCR key blinks twice, then release SETUP.

3.Use the Setup Codes For TV/VCR Combos (on page 19) to locate the brand name and then enter the first four-digit code for your TV/VCR Combo. If you perform this procedure correctly, the VCR key will blink twice.

9continued on next page...