Universal Electronics CABLE 4 manual RE-ASSIGNING Device Keys, To Re-Assign Perform Key Sequence

Atlas Manual rev2 12/27/02 11:08 AM Page 25

RE-ASSIGNING DEVICE KEYS

The Atlas Universal Remote Control can be set up to control a second TV or VCR, or any combination of up to four home entertainment devices. For example, to have the unit control a TV, a Cable Converter, and two VCRs, you will need to re-assign the unused AUD key to operate the second VCR as follows:

1. On the remote control, press VCR once. Then press and hold SETUP until the VCR key blinks twice, then release SETUP.

2. Enter 9 - 9 - 2. The VCR key will blink twice.

3. Press VCR once, then press AUD once. The AUD key will blink twice.

4.The AUD key is now ready to be programmed for your second VCR. See Programming Device Control on page 8.

To re-assign other device keys, repeat steps 1 to 4 and substitute the key sequence using the following chart:

To Re-Assign	Perform Key Sequence
TV as 2nd VCR key:	TV - SETUP - 9 - 9 - 2 - VCR - TV
TV as 2nd Audio key:	TV - SETUP - 9 - 9 - 2 - AUD - TV
TV as 2nd Cable key:	TV - SETUP - 9 - 9 - 2 - CBL - TV
TV back to TV:	TV - SETUP - 9 - 9 - 2 - TV - TV
VCR as 2nd TV key:	VCR - SETUP - 9 - 9 - 2 - TV - VCR
VCR as 2nd Audio key:	VCR - SETUP - 9 - 9		- 2- AUD - VCR
VCR as 2nd Cable key:	VCR - SETUP - 9	- 9	- 2	- CBL - VCR
VCR back to VCR:	VCR - SETUP - 9	- 9	- 2	- VCR - VCR
AUD as 2nd TV key:	AUD - SETUP - 9 - 9 - 2 - TV - AUD
AUD as 2nd Cable key:	AUD - SETUP - 9	- 9	- 2	- CBL - AUD
AUD back to AUD:	AUD - SETUP - 9	- 9 - 2 - AUD - AUD

Upon completion of a re-assignment, the selected mode key will blink twice to confirm your selection. Then, you’ll need to program device control (see Programming Device Control on page 8).

25