Programming a Tune-In Key
1.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice.
2.Enter 9 9 5. The CBL key will blink twice.
3.Select a
4.Press CBL once, followed by the channel number to be programmed (e.g., 3 9 for channel 39).
NOTE: If you are programming a channel for a Digital Cable Converter, you need to enter all channels in a
0 3 9.
5.Press and hold SETUP until the CBL key blinks twice.
6.To add another channel, repeat steps 1 through 5, substituting the new channel to be added in step 4.
NOTE: Programming more than five channels on the same
Clearing a Tune-In Key
1.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice.
2.Enter 9 9 5. The CBL key will blink twice.
3.Press the
4.Press and hold SETUP until the CBL key blinks twice.
This
www.urcsupport.com
19