Universal Electronics M11055BS, DVR/PVR 5-Device Clearing Custom Programming, Troubleshooting

NOTE: Only one device can be assigned to an unused device key at a time.

To Re-Assign	Perform Key Sequence
AUX as 2nd	AUX￿SETUP￿9￿9￿2￿AUD￿AUX
AUD key
AUX as 2nd	AUX￿SETUP￿9￿9￿2￿TV￿AUX
TV key
AUX as 2nd	AUX￿SETUP￿9￿9￿2￿CBL￿AUX
CBL key
AUX back to	AUX￿SETUP￿9￿9￿2￿AUX￿AUX
AUX

To re-assign another unused device key, substitute it for the AUX key above and then perform the sequence. For example, to re-assign an unused AUD key as a second DVD key, perform AUD￿SETUP￿9￿9￿￿DVD￿AUD.

When a re-assignment is done, the selected device key (e.g., AUD) will blink twice to confirm your choice. At that time, you will need to program device control (see “Programming Device Control” on page 8).

CLEARING CUSTOM PROGRAMMING

The Atlas DVR/PVR 5-Device Universal Remote Control with Learning contains a Custom Programming Reset program. You can use it to remove all custom programming, except your setup codes and reassigned device keys.

IMPORTANT: Executing this program will erase all cus- tom settings for Volume Lock, Learned Keys, Tune-In Keys, and Channel Lock. However, your device programming remains.

1.On the remote control, press and hold SETUP until the last-selected device key blinks twice.

2.Enter 9 8 0. The last-selected device key

blinks twice, pauses, and blinks twice again to confirm that all custom programming is cleared.

TROUBLESHOOTING

PROBLEM: Device key does not blink when you press a key.

SOLUTION: Replace the batteries with two (2) new AA alkaline batteries (see “Installing Batteries” on page 8).

www.urcsupport.com

22