Universal Electronics Millennium 4 manual Programming VCR/DVD Player Control

PROGRAMMING VCR/DVD PLAYER CONTROL

NOTE: If you own a TV/VCR combination, skip this section and perform “Programming TV/VCR Combo Control” on page 8.

Locate the brand name of your VCR in Setup Codes for VCRs on the next page, your DVD player in Setup Codes for DVD Players on the next page, and write it in the appropriate space below.

VCR Brand: ________________________________ or DVD Player Brand: ____________________________

The brands are listed in alphabetical order with the most popular codes listed first. You will use one of these codes to program the Millennium 4 to operate your VCR or DVD player:

1.Turn on your VCR and insert a video cassette, or turn on your DVD player and insert a DVD.

2.On the Millennium 4, press VCR once. Press and hold SETUP until the LED blinks twice, then release SETUP.

3.Enter the first four-digit code for your VCR or DVD player. If you perform this procedure correctly, the LED will blink twice.

NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

4.Aim the Millennium 4 at the VCR or DVD player and press POWER once. The device should turn off. If your VCR remote control does not have a POWER key, press PLAY. If the device does not respond, repeat steps 2-3, trying each code listed for your brand until you find one that works. If the device still does not work, try searching for the code (see Searching For Your Code on page 12).

5.For future reference, write your device’s code and type in the boxes and space below.

Device Type:________________________

NOTE: Remember, to use the Millennium 4 to operate your VCR or DVD player, press VCR first.

Page 6 of 15