Sunwave Tech SRC-1600 manual Loading preset codes using auto search

Page 12

SRC-1600 User’s Manual

Loading preset codes using auto search

You can quickly start using your SRC-1600 by using the auto search to load preset codes.

1.Switch on the device for which you want to set up the SRC-1600.

2.Select the appropriate device on the SRC- 1600 using the device buttons. See Selecting devices and pages on page 7.

3.Press and hold for two seconds to enter setup on the touch screen.

4.Press .

5.Point the IR transmitter of the SRC-1600 at the device then press .

6.The SRC-1600 will try to turn off the device by transmitting different preset IR codes. When the device switches off, immediately press any hard button or touch the screen.

7.Ensure that you have the correct code by pressing Volume +/-, Channel +/- or to test. If the code is not correct, press " " or " " and test the code again.

8.Press the button to save and exit.

8

Image 12

Contents SRC-1600 Preface Table of Contents Miscellaneous settings Introducing the SRC-1600 SRC-1600 Features Unpacking the SRC-1600About the SRC-1600 Installing batteries Quick startBattery Indicator Touch screen precautions About the controlsSelecting devices and pages Loading preset codes using auto search About the controls Setting up the SRC-1600 Entering setupChanging the LCD layout Using preset codes Manually setting preset codes Checking the code number Learning codes SRC-1600 User’s Manual Deleting codes Deleting codesDeleting codes one button at a time Deleting codes one device at a timeCreating Macros SRC-1600 User’s Manual Resetting factory defaults Using the SRC-1600 Button protectionRecord button protection Punch thruSRC-1600 User’s Manual Auto power-off Wake up sensorBacklight Miscellaneous settings Using the transmission featurePage Specifications AppendixOptional accessories Troubleshooting Problem SolutionTroubleshooting SRC-1600 User’s Manual Check you are holding SRC-1600 User’s Manual