Sunwave Tech SRC-1600 manual Manually setting preset codes

Page 17

Using preset codes

Manually setting preset codes

1.Find your device in the supplied list of preset codes.

2.Press and hold to enter setup.

3.Press .

4.Find the digit code number from the pre-programmed code list.

5.Use the number buttons to enter the four digit code. (Refer to the pre-programmed code list table.)After you enter the last digit, a double beep sounds, confirming the code

has been input. If the number isn’t in the code data base, the SRC-1600 will beep three times continuously. Please try another number.

6.Check you have entered the correct code by pressing Volume +/–, Channel +/– or .

7.If the code is correct, press to confirm and exit. If the code is not correct, repeat step 4. See Checking the code number on page 14

13

Page 16 Page 18
Image 17
Page 16 Page 18
Contents
SRC-1600 Preface Table of Contents Miscellaneous settings Introducing the SRC-1600 Unpacking the SRC-1600 SRC-1600 FeaturesAbout the SRC-1600 Quick start Installing batteriesBattery Indicator About the controls Touch screen precautionsSelecting devices and pages Loading preset codes using auto search About the controls Entering setup Setting up the SRC-1600Changing the LCD layout Using preset codes Manually setting preset codes Checking the code number Learning codes SRC-1600 User’s Manual Deleting codes Deleting codesDeleting codes one device at a time Deleting codes one button at a timeCreating Macros SRC-1600 User’s Manual Resetting factory defaults Button protection Using the SRC-1600Punch thru Record button protectionSRC-1600 User’s Manual Backlight Auto power-offWake up sensor Using the transmission feature Miscellaneous settingsPage Appendix SpecificationsOptional accessories Problem Solution TroubleshootingTroubleshooting SRC-1600 User’s Manual Check you are holding SRC-1600 User’s Manual
Top Page Image Contents