Sony MHC-GX8000/RG77 operating instructions Precautions

Page 26

26GB

Additional Information

Precautions

On operating voltage

Before operating the unit, check that the operating voltage of your unit is identical with the voltage of your local power supply.

On safety

The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.

Unplug the unit from the wall outlet (mains) if it is not to be used for an extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Never pull the cord itself.

Should any solid object or liquid fall into the component, unplug the unit and have the component checked by qualified personnel before operating it any further.

The AC power cord must be changed only at the qualified service shop.

On placement

Place the unit in a location with adequate ventilation to prevent heat build-up in the unit.

Do not place the unit in an inclined position.

Do not place the unit in locations where it is:

extremely hot or cold

dusty or dirty

very humid

vibrating

subject to direct sunlight

Use caution when placing the unit or speakers on surfaces that have been specially treated (with wax, oil, polish, etc.) as staining or discoloration of the surface may result.

On heat buildup

Although the unit heats up during operation, this is not a malfunction.

Place the unit in a location with adequate ventilation to prevent heat build-up in the unit.

If you use this unit at a large volume, the cabinet temperature of the top, side and bottom rises considerably. To avoid burning yourself, do not touch the cabinet.

To prevent a malfunction, do not cover the ventilation hole for the cooling fan.

On operation

If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player. Should this occur, the unit will not operate properly. Remove the CD and leave the unit turned on for about an hour until the moisture evaporates.

When you move the unit, take out any discs.

If you have any questions or problems concerning your unit, please consult your nearest Sony dealer.

Notes on CDs

Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out.

Do not use solvents.

Do not expose the CD to direct sunlight or heat sources.

Discs with non-standard shapes (e.g., heart, square, star) cannot be played on this unit. Attempting to do so may damage the unit. Do not use such discs.

Note on CD-R/CD-RW playback

Discs recorded on CD-R/CD-RW drives may not be played back because of scratches, dirt, recording conditions or the drive's characteristics. Besides, the discs which are not yet finalized at the end of recording, cannot be played back.

Cleaning the cabinet

Use a soft cloth slightly moistened with mild detergent solution.

To save a tape permanently

To prevent a tape from being accidentally recorded over, break off the cassette tab. Refer to the instructions of the tape.

Before placing a cassette in the tape deck

Take up any slack in the tape. Otherwise the tape may get entangled in the parts of the tape deck and become damaged.

When using a tape longer than 90 minutes

The tape is very elastic. Do not change the tape operations such as play, stop, and fast-winding etc. frequently. The tape may get entangled in the tape deck.

Cleaning the tape heads

Clean the tape heads after every 10 hours of use. Make sure to clean the tape heads before you start an important recording or after playing an old tape. Use separately sold dry-type or wet-type cleaning cassette. For details, refer to the instructions of the cleaning cassette.

Demagnetizing the tape heads

Demagnetize the tape heads and the metal parts that have contact with the tape every 20 to 30 hours of use with a separately sold demagnetizing cassette. For details, refer to the instructions of the demagnetizing cassette.

MHC-RG77 4-238-409-13(1)

Image 26
Contents Mini Hi-Fi Component System MHC-RG77About this manual Table of Contents Main unit How to use thisSurround Speaker Mode Spectrum 8Remote Control 1Connect the front speakers 3Connect the FM and AM antennas Set up the AM loop antenna, then connect itHooking up the system Connect the speaker cords to Surround Speaker jacksTo attach the speaker pads Connect the power cord to a wall outletTo connect optional components Positioning the speakersInserting two size AA R6 Batteries into the remote Setting the clockTurn on the system Press CLOCK/TIMER SET on the remote Press V or v repeatedly to selectOther Operations Loading the CDPlaying the CD Normal Play/Shuffle Play/Repeat PlayProgram Play Programming the CD TracksPlaying the CD To listen to non-preset radio stations Presetting radio stationsPreset Tuning Listening to the radioPress hH again to play the reverse side Loading a tapePlaying a tape Searching for the beginning of a track AMSLoad the CD you want to Recording to a tapeTo select Tape a Press x to stop recordingRecording to a tape Timer-recording radio ProgramsRecording a CD by specifying track order Program EditEnter Turn off the powerMake sure the tape is in forward direction Selecting the speaker System Adjusting the soundSelecting the preset Effect To call up the personal file Sound AdjustmentSelecting the surround Effect Press SurroundSound Adjusting the brightness DisplayChanging the spectrum Analyzer display Mixing the soundFalling asleep to music Sleep TimerSinging along Press Sleep on the remoteWaking up to music Daily TimerAdjust the volume Press CLOCK/TIMER SET on the remote Prepare the music source you want to playTurning off the display Using the displayPower Saving Mode Video Connecting an MD deck Or VCRConnecting a Video Game Player FM antenna Connecting external AntennasConnect an external antenna to improve the reception AM antennaSpeakers Problems and remediesGeneral CD Player Tape DeckPrecautions Amplifier section SpecificationsMHC-GX8000 USA model only CD player sectionGeneral SpecificationsSpeaker MHC-RG66T