Home Theater Direct manual Cloning MX-500ª, Adjustment of LCD Contrast

Page 23

12. Cloning MX-500ª

1.Go to the SETUP mode by pressing the MAIN and ENTER buttons simultaneously for three seconds.

2.Press the CLONE button next to the LCD screen.

3.Press either the SEND or RECV button depending upon the role of the remote control. If the MX-500TMis to be copied from, press the SEND button. If it is to be copied to, press the RECV button.

4.If you wish to clone the entire device, press the ALL button. If you wish to clone only one device at a time, press the DEVIC button.

5.If you press the DEVIC button, it will show all the devices. Press the device button you wish to clone.

6.Set the MX-500TMhead to head with another MX-500TMto be cloned from as shown below. Each unit should be in either cloning from or cloning to mode based on the above steps.

OSD

ON

OSD

12. Cloning MX-500ª

7.Press the START button on both units to begin cloning. It will take about 40 seconds to complete the cloning and it will flash Ò GOODÓ upon completion of the cloning.

8.Exit from the Cloning mode by pressing the MAIN button and then exit from the SETUP mode by pressing the MAIN button once again.

13. Adjustment of LCD Contrast

Pressing the MAIN button and Up on the joystick simultaneously will make the LCD contrast darker and pressing the MAIN button and Down on the joystick simultaneously will make the LCD contrast brighter.

43

44

Page 22 Page 24
Image 23
Page 22 Page 24
Contents MX-500ª Operating Manual Table of Contents Introduction Summary of Operations BatteriesFavorite Channel Buttons Learning From Other Remote Controls Macro OperationsM1, M2, M3, Power and System OFF Buttons Ten Device ButtonsLCD Screen And Button Layout Editing LCD TextCloning The MX-500TM All Other OperationsWhere do I START? System SettingsUsing Preprogrammed Codes Three-Digit Code Number Auto Scan With Three-Digit Number Programming the MX-500TMto Control Your Components Programming The Function Buttons Learning MethodPoints to Remember Programming The Ten Device Buttons Programming Favorite Channels Programming Macro Buttons Programming Macro Functions To The Ten Device Buttons Press CABLE. This takes you to the Cable device Programming Punch Through Functions Erasing Learned Buttons Erasing Existing ProgrammingErasing Favorite Channel Buttons Erasing Punch Through Functions Erase Macro Functions In The Ten Device ButtonsTo Create Or Edit Text for Favorite Channel Buttons LCD Button EditingTo Create or Edit Text on Function Device Buttons + etc Setting BacklightCloning MX-500ª Adjustment of LCD ContrastComponent See device Low Battery MessageMemory Lock GlossaryGlossary Pause See Delay Specifications WarrantyAudio List of Preprogrammed LCD Text by DeviceCable Audio Set-Up Code TableThree-Digit Preprogrammed Code Table SAT Admiral VCR DVD CableCalifornia Audio Tape AUX AUX Light, Switch, Tivo, etc
Top Page Image Contents