SYSTEM FEATURES
| Remotely start your car to run the heater, air conditioning or defroster from an extended |
Remote Control | distance. |
Keyless Entry | Remotely locks and unlocks your power door locks. |
Trunk Release/Sliding Door | Remotely open your power trunk or your power sliding van door with a push of a button. |
Remote Programmable Run Time | Remotely program your vehicle to run 5 to 15 minutes. |
Run Time Confirmation | Remotely check the programmed run time of 5, 10 or 15 minutes. |
Tach/Tachless Option | A programmable feature that lets you choose from the easy to install tachless operation or |
| the |
Parking Light Confirmation | Confirms that your vehicle has received a remote signal and will remain on if the engine is |
| remotely started. |
Dome Light Supervision | Never walk up to a dark vehicle again. When unlocking the doors by remote control, the dome |
| light will come on and stay on for 1 minute. This feature will shut off when you activate the |
| ignition switch or step on the brake. |
Cold Start | Remotely program your car to start at a preset temperature. Automatically starts your car in |
| freezing temperature so you never have a dead battery. |
Pit Stop Mode | Allows you to exit the vehicle while the engine remains running without leaving the key in |
| the ignition switch. |
Extended Range | Allows you to operate your system from up to 400 feet away. (800 feet for E Models) |
Code Learning | Allows your remote starter to learn new remotes, should you want to add remotes, or if remotes |
| are lost. |
Limited Lifetime Warranty | Guarantees |
SYSTEM COMPONENTS
Your system includes: | 1- Extended Range Antenna (E Models Only) |
1- Four Button Remote Transmitter | 2- Window Antenna Clips (E Models Only) |
1- Main Control Module | 1- Warranty |
1- | 1- Warning Sticker for Under the Hood |
1- | |
6- Heavy Gauge Wires w/ Spade Connectors | 1- Installation & Operation Guide |
1- Hood Pin Switch | 1- Bonus Installation Kit (with selected models) |
REQUIRED TOOLS
You may need a 5/16 inch drill bit when mounting the hood pin switch. In most cases no additional tools are required, however if the bottom of your dash on the driver’s side will come off you must remove it. In this case a screwdriver or wrench may be needed.
TECHNICAL ASSISTANCE
Should you need help. First check our website at www.bulldogsecurity.com for the most common installation problems or then our
Before you begin, check our website at www.bulldogsecurity.com for complete wiring information for your vehicle.
You must give the following information: •Name
•Telephone Number with Area Code (Fax number if applicable) •Year, Make, and Model of the vehicle
•The model of the system you are installing •The type of assistance you are requesting
If you give the above information you will be called in the order your call was received. | 1 |
|