Bulldog Security RS1100E manual Remote Starter, Contents, Installation Guide, Owner’S Guide

Page 1

•

REMOTE STARTER
MODELS RS1100/RS1100E, RS114
CONTENTS
System Features	1
System Components	1
Required Tools	1
Technical Assistance	1
Before You Begin	2
Precautions	2
Using your Test Probe	2
Making Connections	3
Locating & Making Connections	4-6
Neutral Safety Switch	6
Connecting Wiring Harness	6
Antenna Placement	7
Anti-Theft System	7
Optional Features	7-9
Operator Programming Instructions	9-10
How to use Your Remote Transmitter	10-11

Technical Assistance

All tech personnel are expertly qualified to answer any technical questions.

Technicians are available Monday through Friday from 9:00 a.m. until 8:00 p.m. and Saturday 10:00 a.m. until 4:00 p.m.

Address

288 Canton Avenue • Wintersville, Ohio 43953

Telephone

Phone: 740-264-4710 • 800-878-8007 • Fax: 740-264-7306

Image 1

Contents REMOTE STARTER CONTENTSINSTALLATION GUIDE OWNER’S GUIDESYSTEM COMPONENTS SYSTEM FEATURESREQUIRED TOOLS TECHNICAL ASSISTANCEBEFORE YOU BEGIN PRECAUTIONSUSING YOUR TEST PROBE Wire Tie MAKING WIRING CONNECTIONSMAKING END TO END CONNECTIONS Electrical TapeUse this method ONLY when connecting two separate wires end to end Wire TieLOCATING & MAKING CONNECTIONS Note Remove any paint below the spade connector Spade ConnectorFactory Bolt ACCESSORY WIRES THAT POWER THE HEATER/BLOWER MOTORCONNECTING THE WIRING HARNESS NEUTRAL SAFETY SWITCHCONTROL MODULEFACTORY ANTI-THEFT SYSTEMS ANTENNA PLACEMENTOPTIONAL CONNECTIONS TESTING Door Locks There are three basic typesWHITE MODULEBLACK “Type A” + Positive 5-pin harnessNEGATIVE TRUNK SLIDING DOOR RELEASE ONLY OPERATOR PROGRAMMING INSTRUCTIONSGround TO FACTORY TRUNK/SLIDING DOOR WIRE WIREBULLDOG HOW TO USE YOUR REMOTE TRANSMITTERDual Pulse Door Lock Dual Pulse Door Unlock

REMOTE STARTER