Reset, Additional Programming Information

Synergy.doc

function. In the remote's TV mode, this button changes the Input Source (Input 1, Input 2...) on your TV. In the remote's VCR mode, this button changes the TV / VCR Input on your VCR.

You can program this button so that in the remote's Cable mode, [INPUT] will operate the Input function on your TV or VCR, eliminating the need to change modes on the remote.

To program [INPUT] to operate your TV Input function in the remotes cable mode...

1.Press [INPUT], then [OK] together until the [CBL] button illuminates.

2.Press [TV]. The [CBL] button will blink 3-times and go out.

Note: You can also press [VCR] in step 2 above to operate the TV / VCR function on your VCR. Or press [CBL] to return to the normal CBL Video Source function.

13. Reset

To reset your remote control to its factory default settings…

1.Press [CBL], then [OK] together until the [CBL] button illuminates.

2.Press [MENU], then [MENU] again. The [CBL] button will blink 3 times and go out.

Reset returns the ALL SmartKey®, Volume / Mute, Mode Lock™ features to their factory default settings.

14.Additional Programming Information, Troubleshooting, Terms

Additional Programming Information

1.The power / mode buttons will illuminate in slow-rotation (i.e. CBL Æ TV Æ VCR Æ DVD Æ AUDIO Æ CBL…) while the remote is in a programming mode. In the absence of a keypress entry, the power / mode buttons will stop illuminating after 45 seconds and the remote will exit the programming mode.

2.When programming the remote control using the [CH +] or [CH -] buttons (Power function) in the Point and Press® Programming method, you may find a code that turns a device off but not back on. If this happens…

a.The correct code has not been found as you may have a code that operates some but not all of the functions of your device. Continue pressing [CH +] until your device turn on.

b.You may have gone past the correct matching code. Try pressing [CH -] one press at a time until you find a code that turns your device back on.

3.When using the Point and Press® Programming method, you can also program your remote using buttons other than the [CH +] or [CH -] as described in Section 5 as follows:

a.[VOL +] – to “go forward” through the codes using the “VOL +” function on your devices.

b.[VOL -] – to “go back” through the codes using the “VOL -“ function on your devices.

Note: When you find the correct code, the volume of the device being programmed will increase or decrease.

c.[S] - to “go forward” through the codes using the “CH +” function on your devices.

d.[T] - to “go back” through the codes using the “CH –“ function on your devices.

Note: When you find the correct code, the channel of the device being programmed will increase or decrease.

e.[XX] - to “go forward” through the codes using the “Fast Forward” function on your devices.

f.[WW] - to “go back” through the codes using the “Rewind” function on your devices.

-13 -