Integra DLV-100 instruction manual Troubleshooting

5. TROUBLESHOOTING

This section helps you resolve problems you may encounter while setting up or using the projector.

Power/Status Light Messages

Condition	Power Indicator	Status Indicator	Note
Standby	Steady orange	–	–
Cooling down	Blinking green	–	Blinks green for 90 seconds
Lamp in Normal mode	Steady green	–	–
Lamp in High-Bright mode	Steady green	Steady green	–
Retrying to turn on lamp	Steady green	Blinking orange	The projector retries 3 times at an interval of 15
			sec for max. 45 sec)
One minute after lamp is turned on	Blinking green	No light in Normal mode / Steady green	–
		in High-Bright mode
Lamp has reached its end of life	Steady green	Steady red	Message appears on screen during 1500-1600
(High-Bright: 1000 hours or over)			hours (1000-1100 hours: High-Bright mode) of
(Normal: 1500 hours or over)			lamp usage. The projector reaches its end of life.
			Please replace the lamp as soon as possible
Lamp life has reached its end of	Steady orange	Steady red	The projector is in standby mode and cannot be
life			turned on.
(High-Bright: 1100 hours or over)
(Normal: 1600 hours or over)
Lamp cover error	Steady orange	Blinking red (1 sec interval)	The projector is in standby mode and cannot be
			turned on.
Temperature error	Steady orange	Blinking red (4 sec interval)	The projector is in standby mode and cannot be
			turned on.
Fan error	Steady orange	Blinking red (8 sec interval)	The projector is in standby mode and cannot be
			turned on.
Lamp error	Steady orange	Blinking red (12 sec interval)	The projector is in standby mode and cannot be
			turned on.

45