Integra DLV-100 Adjust the Tilt Foot, Adjust the Image Using Auto Adjust, Up down

Adjust the Tilt Foot

1)Lift the front edge of the projector.

2)Press the Tilt button on the top of the projector to extend the adjustable tilt foot (maximum height).

1

Adjust the Image Using Auto Adjust

The Auto Adjust function automatically optimizes the image in RGB mode.

[Poor picture]

[Normal picture]

3)Press and hold the Tilt button.

4)Lower the front of the projector to the desired height and re- lease the button to lock the Adjustable tilt foot.

There is approximately 5 degrees of up and down adjustment for the front of the projector. The rear foot height can be changed, but the vertical distance from the bottom to the desk or floor should be 0.14 ” (3.5mm) to make the projector horizontal on the flat surface. To fine-adjust the height of the rear foot, re- move the spacer (black rubber) and rotate the rear foot to the

desired height.

*If the projected image does not appear square to the screen then use keystone correction for proper adjustment.

4

up down

Do not use the tilt-foot for purposes other than originally intended. Misuses such as gripping the tilt-foot or hanging on the wall can cause damage to the projector.

E

N

T

E

R

CAN

PC CARD

Press the Auto Adjust button to adjust Position-H/V and Pixel Clock/ Phase for an optimal picture. Some signals may not be displayed correctly or take time to switch between sources.