Mitsubishi Electronics WD-62827 Locking Screws and Wedge Removal, 52 & 62 Side Locking Screw

MODELS: WD-52627 / 52628 / 62627 / 62628 / 62827 / 62927 / 73727 / 73827 / 73927

WD-73927

1)Remove (16) screws (A). 8 on each side. (Remove only the outside screws. Do not remove inside screws, they are for the Screen Frame)

2)Pull Front Panel Escushions from unit.

AA

AA

3) Remove (8) screws (B) and remove the Pedestal Cover. Mechanical adjuster is now accessable.

BB

Locking Screws and Wedge Removal

Before mechanical adjustments can be made, locking screws must be loosened.

•[B-1] is located on the front of the UNIT-ADJUSTER. (Figure 1)

•In 52” and 62” models [B-2] is accessible from the rear of the unit on the right side of the Optical Engine (from the rear). (Figure 2)

WARNING: DO NOT loosen [B-2] too far. The nut on the other side may drop off. Then then Optical Engine must be removed to re-install the nut.

[B-2]

Figure 2: 52” & 62” Side Locking Screw

Page 49